My powerbook G4 has a button thats used to unhinge the LCD screen and flip the computer open. When I flip it open, the light turns on, but it should be off. If I pull the LCD screen forward as if I am going to close the screen, the light turns off as I am pulling the screen forward. As soon as I stop the motion, the power light goes back on. Its very odd.
I had an iBook, now I have a powerbook. Both have the feature when I shut the computers and they are in sleep mode, the light goes from dim to bright to dim to bright..... It drives me nuts. I have to put my computer in a drawer or cover it up at night. Does anyone know how to turn the light off? or have it be constant? Is there a download that fixes it?
The plastic piece around the dc jack is broken and blocking the power adapter from being able to charge. Is this piece required or can I remove it? Does anybody know where I could get a replacement piece?
I searched forums etc. I have a 867 12" powerbook. The problem is that it will not turn on at all. I took the battery out and pressed a few key and it worked for a little while. Now when I plug it up to recharge the light goes green to red then off. I found a so called reset button on the apple site and lifted the keyboard and it is not in site.
I have a 12 inch powerbook g4 Aluminum and the screen is dim,and discolored in some areas but it is really bright at the bottom like it supposed to be brighter.is it the backlight and inverter or is it just the lcd? it works flawlessly other than that.
I've got a Powerbook G4 that has a booting issue. I will hear the startup "dong" a whirl of the drive, then it doesn't go to the grey screen with the Apple. It just sits there with a black screen.If I wait a few hours and try it, sometimes it starts up fine, or sometimes it will sit on the grey screen with the Apple symbol and do nothing.If it does boot correctly, none of the USB ports work. Any ideas on if its worth trying to repair since its 2 and a half years old and I didn't get the Apple Extended Service plan?
Hoping that some of you here still own or have owned Powerbooks recently... I have a PB G4 1.67ghz that I bought in July 2005. Since then, it's seen the back of the Apple Store several times to replace three logic boards, a screen, and a SuperDrive, with the most recent instance being the third logic board replacement. This has left the future of my laptop in uncertainty, as the warranty expires this July. In the past, I've owned several Macs for 5 years or more, including my beloved G4 Cube, so I'm no stranger to sticking with my Mac until it's absolutely necessary to upgrade... and financially, I was planning for this computer to last me another 2 years before I had to upgrade.
I was wondering if anyone can help me on this. I have a powerbook G4 15" and sometimes, the number 7, J, U, & M keyboard keys don't work. This is only sometimes, but it's becoming more frequent. Does anyone know how to fix this?
I have a 12" PowerBook G4 (the very last revision in 2006) and I've never had issues with the bluetooth before (although I've only ever used it to move a few pictures from my phone to my laptop occasionally). This week, I bought a wireless mighty mouse and connected it no problem. Yesterday was the first day I used it and it worked like a champ all day. Today, I was using it and in the middle of moving it around, it just stopped responding. My trackpad still works fine, but the cursor stops moving with the mouse, the clicker doesn't work, etc. When I turn the mouse off for a minute and then turn it back on, it works for a few minutes and then quits again. The first thing I tried was to swap batteries, but that didn't help. Neither did a restart.
recently my powerbook g4 has been doing some funny things. ..--Sometimes it won't turn on when pressing the button but eventually it will. --The computer would not book up earlier and would just stay on a white screen, like the white screen you normally get when booting but without the apple logo.--When my computer eventually booted it worked for a couple of mins and then the screen went a tinted black colour and a box came up in the middle of the screen saying i need to reboot (the box had a power logo for the background)--Then i rebooted and as i was rebooting a black screen came up with lots of writing in white. A bit like on a windows pc.
I was using my trusty powerbook 500 mhz and when i closed the screen while the machine was on, after @ 1/2 hour i opened the screen up and NOTHING!. i restarted and nothing again, the caps lock key will light up, so i am assuming the power supply is ok. No chime and black screen, any suggestions on what it might be...im thinking logic board, if so what ones will fit that model
I bought a Powerbook G4 17" 1ghz off of ebay, knowing it has latch issues (not catching). I was wondering if there was some way I could fix the latch myself that was not invasive (dont have to remove the bezel), or if there was a way apple would repair it for free since it wasnt from a drop(says prev. owner). IF there isnt, I was wondering if a magnetic strip applied to the case and bezel would keep it closed, or harm the internals...? Would velcro adhesives work? I would rather not use a wrap-around solution to clasp it shut
About the Powerbook G4 17" sound quality. It sounds almost the same as my Powerbook G4 15" 867mhz did, isnt it supposed to be a little louder than that? Could anyone describe their experiences with the PBg4 17" an sound volume?
I have a 1.67 GHz Powerbook G4. This morning it was fine. When I got home from work, it decided that it suddenly no longer wants to stay on when not plugged in. The battery is showing a full charge. The light on the plug is green. But the second I unplug the cord from the laptop, the entire thing shuts down.
I have a 17" PB, 1.33 ghz with 1.76gb ram. In September it gave signs of the hard drive failing. It would crash right after booting and then not boot at all.If I booted into target disk mode i could still access the files. I backed everything up and did many versions of trying to reformat / reinstall my OS to no avail. When Leopard came out I went through the process again to see if that might help but it didn't. Today I replaced the HD and now it still won't boot at all. It goes to the grey apple screen with the rotating loading icon and stalls. I've let it sit there for 10 minutes or more.
I am leaving for a week long trip and many parts of it will not be able to run the computer off of the powercord, which is a problem because I get about 40mins of wordprocessing use out of it when I run the battery alone. Can someone explain what the significance of these levels are for my Powerbook G4 15'' (Alm) 1.25GHz, namely the cycle count and full charge/remaining capacity?
I finally purchased my dream laptop a month ago and it has been great so far until I ran into this strange issue. It seems when the backlight it set to below 50% and either my hands are on the side/bottom or I'm slightly moving or tilting the laptop the backlight goes into this weird super-bright state for a few seconds. When this happenes there are even brighter circle shapes near the dock area. Problem is this only happens sometimes and I cant seem to replicate it with a certain action. I'm not sure what will happen when I take it into the store. If anyone can shed any light onto similar problem
On my mac mini I get a printer window which allows me to select duplex printing. On my powerbook G4 I get a menu with far fewer options. THis has not always been so, I used to get the same window and options with both computers. If upgrades to OSX have caused this how can I get round the problem
My 12 inch powerbook does not start up. Instead it loads to Darwin. I have an install disk from a 15 inch powerbook G4 and I would like to know if using this would work on my 12 inch powerbook G4?
Up until recently my PowerMac G5 has performed as it should for a computer its age. About two nights ago it shut itself down and I haven't been able to turn it on since. Power does cycle through the unit because all the fans will either cycle once or twice, or at the very least they will twitch. And now there's a tiny red LED on the motherboard and behind the power button that lights up whenever I try to power on the computer. I'm at a loss for where I need to go from here, though I feel rather certain that my computer has simply passed on. It's an original 2004 1.6 ghz single processor PowerMac G5, serial number unknown, since I can't turn it on.
I bought 4 G4 towers of eBay for �85.. none have Hdd's so havent tried them out yet (two also have no graphic cards) I got a mix of ram size and speed (pc100/pc133) however thats not my question
Next to the ram slots theres a red light that comes on, is this normal? I've tried to do some research on it and some people say it is, others say it isnt.
I plan to sell them off again on ebay but I did it mainly as a project to keep the G4's alive. Any suggestions on graphic cards (cheap ones too)?
[URL] I went here. I have found out the iMac is a 2nd gen iMac G5. It has an ambient light sensor. I put my hand over it and it doesn't appear to actually do anything.
What is it supposed to do?
Do new ones have it? I have a 20" aluminum one as well, but don't see a sensor.
So I've done all I can find on the internet on helping my broken computer. It used to have the noisy fan issue and then it would shut off. Now after being off for 12 hours, it may shut off in 2 minutes, maybe in 30. I have reset the SMU by unplugging for 10 seconds and then plugging in while simultaneously holding the power button, then turning it on. Ive also reset the PRAM, but it still seems to shut off. Is it a bad power supply? I dont ever hear the fans blowing hard anymore.
If anyone has basic things to do, I'm all ears. I know last step is probably just reinstall OSX.
I have a PowerMac G4, dual 1.25, 2 gigs of RAM and I'm thinking about upgrading. I don't have a big budget so the new Mac Pro is out of the question. I've been trying to figure out what's going to be more beneficial for me: 1) I upgrade the processor on my G4 to the maximum of dual 1.8 or 2) get an iMac, maybe the lowest version of 2.4Ghz Intel core duo.I'm an audio engineer and my projects require a lot of audio recording, mixing, and mastering. Once in a blue moon I have to work audio synced up to video. That was the reason I HAD to get a PowerMac 4 years ago and not the old version of the iMac. All my software work perfectly with OS 10.3.9 so it's not a requirement for me to get a better operating system. In fact, one application is still not available for OS 10.5.
I have a Powerbook G4 1.5 w/ 1GB of RAM and the stock 80GB HD. I've run this puppy pretty hard for a couple of years now, and it's lately started to lag a bit - perfectly natural. I was considering buying a new notebook but I've decided to wait until after Leopard comes. So my question is:
1) How do I determine the max RAM I can put in this machine? 2) Are there are specific specs I need to be concerned with when swapping out the Hard Drive? Any type, size limitations, speed limitations, etc.
I'd love a little input as to how I find out this info. I think instead of taking the notebook plunge now, I'm going to put a nice new hard drive in this one and possibly bump up the RAM a little more if it will take it.
So is the is Powerbook G4 802.11g or b? it is the 1.25GHz model. Also, one thing I don't understand regarding the airport extreme or any airport for that matter: isn't the maximum speed going to be completely determined by how much the cable provider, Comcast, pumps out?
If this is the case, how do I determine what my transfers and speeds are looking like specifically for Comcast? And, how would an airport extreme improve upon this or any other performance aspect in this regard?
Powerbook G4 (Ti-book) 667 mhz, 512 mb RAM. I finally after YEARS upgraded my OS (10.4.10), yay me! Just bought Adobe CS3 (for the new IMAC we have yet to buy), but I would like to install it on my Powerbook. SO, it it time to bump up to 1GB RAM. I was told it was tricky, and I should take it in to the apple store to install, but then I took a look under the keyboard, and it looks pretty simple. i have installed new RAM on a G5 tower, and this looks way easier. So, I am planning on buying the RAM either online or at FRY's, then installing it. BUT, I know I have to be careful of what type of RAM to buy. I found what I think will be good at [URL] but I will have to buy 2 (512's) as mine currently has 2 (256). I guess I just want to make sure I am not going about this the wrong way before I drop about $200 for RAM upgrade...
I have a 15' Powerbook G4 1.67, currently with 512 of ram....so i'm shopping for an upgrade, but not sure which specific type to go with. In my system profile it says i'm running..
Type: DDR SDRAM Speed: PC2700U-25330
And these are the types i've been seeing to choose from.