Important: Includes wide width connector (approximately 1.5 inches wide). This display will not work with iBook G4s with a narrow display data cable connector. The correct LCD for iBooks with a narrow width connector can be found here.
[URL]
I have an iBook G4 which I want to use with a widescreen external display. I am not interested in gaming or doing anything fancy just surfing the web and working on documents and maybe looking at movies. I already have a hack that enables me to use a regular display which doesn't mirror the iBook screen. I just wondered whether I would encounter problems using a wide screen display and what the maximum resolution I should look for.
View 3 Replies View RelatedThis is quite an interesting situation I'm in.
Today during High School, my first period, I noticed a Mac iBook G4 in the recycle pile used by my schools Tech department. I decided to swoop it up and give it a whirl, and see for myself what the problem with it was.
When I first powered it on, I was receiving a scrambled signal on my display. It was merely a white screen with lines in it, after a while of tinkering, even grabbing a few mac knowledgeable buddies of mine to see if they could do anything. It seemed like this would drag on, and I would not fix it.
In the end, we ended up tapping the screen and seeing a faint hope of light, that light was the appearance of the desktop! Unfortunately, the screen soon vanished back into it's scrambled state. Upon further tapping, we could only figure it was a problem with the connection of the display to the logic board.
My sister has just broken off the central pin to her iBook G4 which is now wedged inside the connector. Obviously the ac adapter is screwed and needs replacing but short of pulling out the offending pin from the inside of the connector, would I have to replace the power supply? How complicated is this? Cost? Any guides etc?
View 3 Replies View RelatedIm trying to rebuild a 20inch g5 imac. While replacing the bezel today i removed the screen and broke the pins that connect the connector from the motherboard. Can this be repaired or must I purchase a new screen?
View 1 Replies View RelatedI have a G3 iBook and just the other day the display stopped working. There were no signs of the display going bad, it's just went. Am I able to boot the iBook via Target Disk Mode on my PowerBook and run the iBook Hardware Test CD on it? Also, can I reboot my PowerBook and choose the iBook as the startup volume?
I know how to do Target Disk Mode but the latter I'm not sure about.
I have an ibook 500 mhz with a mini VGA port and I want to hook it up to an apple 17in studio display with ADC. How can I go about doing this?
View 5 Replies View RelatedMy daughter has an iBook G4 which she loves and uses daily for school. When she turned it on today it would power up but no display. The CAP Lock key will light up. I have reset the PRAM and PMU but no luck.
View 2 Replies View RelatedI got an 1.33 Ghz G4 iBook logic board, given to me as a working part. However, nothing else that goes along. I do have all the basic cabling such as speaker and power button, flex cables and such. Also got myself a new external AC power adapter. Now, I do not intend to use this as a laptop, thus, I will not be looking for a battery, just AC use. However, there's a big problem, I've no screen. I know there's this software hack that allows to connect an external display, in order to have a "mirroring" desktop.
I suppose that'd be achievable if I had the original screen to actually do the hack, but I don't have it. So, is there a way that I can just directly connect an external display and completely forget about the internal one? One more thing, suppose I can't do what I have in mind, if I actually found and borrowed an internal display, would I be alright if after the hack I give the internal display back to it's owner and continue with the external?
My homeroom teacher's 14 inch G3 iBook's display has started displaying everything grainy. There are little dots everywhere on the display, and it is annoying. The head IT person at school is stumped. I am not sure of the exact version of OS X, if it might be a software issue. Could it be a sign of logic board failure?
View 14 Replies View RelatedI am creating a new image for some old iBooks that will be used in a school. To run a specific program I need to have OS 9.2 installed because it won't work any other way(even through the simulator). I have OS 10.2 installed on the master image iBook computer and have installed OS 9.2 through the restore disks. I can load up to both OS X and OS 9.2 but OS 9.2 does not take up the entire screen. It's contained within a small box in the middle of the screen.
View 1 Replies View RelatedMy ibook has been working great and all of a sudden I have no display. It boots up fine, the eject button works, I can hear the volume if I turn it up or down. This is my second ibook and I really need this one to work! Its only 4 years old 800mhz,256,30GB. There are no apple repair places anywhere (other than the apple store) around here, so I'm not sure if there's something that I can do on my own?
View 4 Replies View RelatedI have a iBook G4 with a broken backlight. The iBook was custom painted Maroon (Only the back part of display and around the keyboard), and I don't like it. Will an iBook G3 12" display work on the G4?
View 6 Replies View RelatedA friend gave me one of these, said he didn't test it. i tested it but have observed the following: ring on PSU plug illuminates fine, was orange but now greed thus battery charges ok. battery button works too, pressing that initially showed 1 dot, now shows 4. charge ok and accepted. pressing the power button though, i hear the fan spin for 1 sec, the disk and the cd drive click in, but no chime and nothing on the display. no response nothing, a hard reset (hold power) turns it off. I did the PMU reset, and the pmu did do a reset, but nothing. I also did the PRAM, and again nothing. I am suspecting a faulty logic board, I hope i can get this going as aesthetically it's in good condition. For the info it appears to be an iBook G3 model A1007, If you need any more info then give me a shout.
View 2 Replies View RelatedI have a 14'' iBook and recently bought an LG 19'' Widescreen monitor. I am testing a Dell 17'' on it right now before I open the LG one, but my problem is that the same screen shows on my ibook and the external. This isn't what I want. I have read you are supposed to be able to close the laptop and then it shifts to the external display but this is not working for me.
This is my goal:
Use my bluetooth keyboard full time
Have my ibook closed at all times
Have my external as my main display
How do I make this work?
Is it possible to connect my iBook G4 to my Apple 20" Cinima display without buying a VGA to DVI converter?
If not why?
If so how?
I have an old Dell CRT I'm using currently with my iBook and I want to know how I can just use the display and close the iBook when at my desk without the computer sleeping. Currently if I try waking the computer with the keyboard or mouse, it wakes up for about five seconds before going back to sleep. Is there any way around this or do i just have to keep the iBook Open?
View 2 Replies View RelatedI'm trying to get an accurate identification of the iBook white G/3 700 MHz with 12in display we just acquired. There seems to be a couple of very similar models. The Apple Support article is unclear [URL]as to which one we have. One model is an early 2002 release (M8602LL/A), the other a late 2002 release (M8860LL/A).
View 2 Replies View Relatedalso posted on apple discussion forums. My wife has a 12" ibook g4 1.33 mhz. It has been exhibiting the following symptoms with increasing frequency:
1) the display will completely dim to the lowest setting or cycle between bright and dim, as if pressing f1 and/or f2 repeatedly
2) some of whatever she was typing or working on at the time will be deleted
3) a string of repeated characters (usually q1aq1aq1a) will appear in her typing
4) often the desktop is brought to the front as if pressing f11 in expose
5) other than the problems described, the computer continues to work normally
6) problems are almost always related to moving the hinge position, but sometimes happen randomly, with no movement at all
7) it will sometimes occur many times a day, then not at all for several days
8) it seems to happen more often when the computer is not on a hard surface, but this may just be my imagination or some random bad luck
I am at a loss as to what the problem may be. I was thinking it might be the display cable because of the link to hinge position, but that wouldn't account for the random typing. Then I thought it was the motherboard, but the computer seems to work ok other than this. I did realize the other day that most of the problems are things on the left hand edge of the keyboard (display brightness, the q1a pattern), but this doesn't account for the deleted typing and the mysterious f11 thing. Does anybody have any thoughts? Am I looking at a display cable (hopefully this is it - I have no problems with disassembling/reassembling things)? Or is it the motherboard (probably means it would be more economical to get a new machine)? Or is it something else?
Was thinking about accessories for my MBP and I was thinking about the display port. What I want to do is when on vacations plug my MBP into the TV and show the pictures I took. I know Apple used to give them to you for free when you got a new MacBook or MacBook Pro. But since most were wasted, they stopped. So now, if you call Apple Support or whatever, can you get one for free per request? I really don't want to pay $30 for this little cable.
View 11 Replies View RelatedA few weeks ago, I discovered that when my Mini Displayport to VGA connector was plugged in, I heard a buzz through my speakers. It didnt bother me that much, so I just dealt with it. However, today I was plugging my external speakers in, and when the connector was about half way in.. I started to hear audio that I knew wasnt on my computer. Turns out it was commentary on a college basketball game. I started to listen some more, and discovered that it was 1530am. Seeing as I use just a standard set of 5.1 computer speakers... I found this to be extremely odd, so I figured id share this with everyone.
View 7 Replies View RelatedI would like to know if someone knows if there is a way to plug in my unibody Mac Book with Mini DisplayPort to my old TV with S-Video?? Looks like apple don't make this because the only I saw was Mini DVI with S-Video. How can I make this work.
View 3 Replies View Relatedi was wondering, how hot is the little magsafe connector on the mac book pro supposed to be. i've heard about issues of them burning so i wanted to make sure of the heat issue. when i touch the sides of it it's pretty hot, hotter than the rest of my machine. is this normal?
View 5 Replies View RelatedLooking at the Apple online store, the 24" Apple Cinema Display comes with:What's in the Box * LED Cinema Display* AC power cord* Cleaning cloth* Printed documentation So, my question is, do you have to buy the actual connector cable separate, or is it permanently attached to the display? I would like to connect it to a brand new MacBook Pro 15".
View 5 Replies View RelatedI've just bought a MBP 15" and am wondering if I can connect a 24 inch monitor too make it a extended display. Can someone make a recommendation on what monitor (24 inch) display to buy? And Which connector to get so I get full resolution on the external display?
View 7 Replies View RelatedI just bought a new Logic Board for a 1.25Ghz eMac and I've put almost everything back together after installing it until I ran into a problem. The power button cable that runs from the power button on the casing into the logic board has no connector on the Logic Board itself, now I have an old logic board that whilst being broken has a connector on it but I really don't want to have to solder the connector on for fear of breaking the logic board.
View 3 Replies View RelatedI was attempting to replace the hard drive in my eMac, but for instructions I HAD to follow some darn take-apart guide that said pull out the connection for the power button cord from the logic board. I didn't know that it was SOLDERED in there, and now I can't complete putting my eMac back together without doing so.
Can this be fixed without having to send it to Apple? Does it HAVE to inolve soldering, or is there an alternative? Is there a way I can temporary have my eMac power on until I get the connector fixed?
I've tried re-installing and updating every possible graphics related driver for Windows 7 i cannot for love or toffee get the bloody thing to even recognize my display. I am using a 26" tv as an external display, it works on OS X (very easily), windows XP (also very easily) and even Vista (also easily) and connecting through a DVI/HDMI connector. Why not windows 7? I've scoured the web for answers but can't find anything. Is anyone at least in the same boat as me? I really need this solved soon
View 1 Replies View RelatedMy brother's iBook G4 (800Mhz, First Rev) has completely splattered itself and we're getting a new Macbook for him under insurance. My iBook G3 (White, 900Mhz G3..the last G3 Rev of the iBook) has a failing hard drive.
Now, could I swap out those two drives, at least to recover stuff? And is there a specific method of opening up the iBook G4 so that I don't break stuff (I've already messed with my G3..and ended up with a dozen extra screws ^_^
Mainly the aim is to salvage the hard drive and swap them out; replacing my faulty iBook G3 one with the iBook G4 one which is perfectly fine.
My iBook G4 power supply failed and I'm awaiting a replacement. In the mean time, can I use the power supply from my iBook G3 with the iBook G4?
View 1 Replies View Related