MacBook :: OS X Will Not Start - Just White Screen No Logo
Jun 3, 2012MacBook mac OS will not start. Just white screen no logo. All was well until I went through aiorport security?
Info:
MacBook, Mac OS X (10.7.4)
MacBook mac OS will not start. Just white screen no logo. All was well until I went through aiorport security?
Info:
MacBook, Mac OS X (10.7.4)
I am stuck in my MacBook pro which shows white screen.
1- I tried hold C to Bogor from DVD to reinstall Mac os x , but it's not working .
2- I tried hold Shift and option to log to safe mode , but it's not working .
3- I tried reset ram, but its not working.
I am stuck and can't do anything.
Info:
MacBook Pro
My MacBook Pro won't boot past the white startup screen with the Apple logo. After doing some trouble shooting my best guess is that the issue is either an issue with the logic board or the hard drive, but I am no expert so I may not be right. Here is what I have tried so far. I have done all these steps multiple times and the results have varied, but here are my most recent results:
1) First off, there are no peripherals connected so that is already ruled out as the cause.
2) When I try starting up in safe mode (holding shift while starting), the Apple logo, spinning wheel and progress bar appear. The progress bar fills about a third of the way then stops. I have left it for quite a long time and it still stays at a third of the way.
3) When running a safe boot (holding shift+command+v at startup) it gives me a " SATA WARNING: Enable auto-activate failed" message, and then eventually times out. Here is the full message:
4) Resetting the PRAM (holding option+command+p+r at startup) does the second chime but only results in the flashing folder icon with the question mark.
5) I tried booting up the computer in single user mode (holding command+s at startup) and running fsck -fy, it again gives me a "SATA WARNING: Enable auto-activate failed", then eventually times out. Here is the full message:
6) I tried booting in recovery mode (holding option while starting). When I do this I do not get the OSX utilities screen. Instead I get a white screen, sometimes my hard drive shows up on the screen, sometimes it does not.
If i boot in recovery mode with my osx install disc inserted the disc appears. If I select the hard drive we are just back to the apple logo and spinning wheel. If I select the install disc it goes to the apple logo/spinning wheel again, sometimes it allows me to start running the install, but then when it gets to the step where you select the hard drive to run the install on, no hard drives appear.
So that's where I'm at. I do not care about losing any data because luckily I backed up this machine right before this started happening.
My mac desktop was working this morning, locked up and then when I rebotted it it stays on the logo screen. Any suggestions on getting passed it?
Info:
iMac
I have had my MacBook for almost two years and the battery had just died on me. So I sent it back to Apple and got a new one. But ever since switching over to this new battery, my computer has had issues starting up. A grey screen fades into white and the Apple logo never appears. The computer will just stay like that for hours. A friend suggested turning the power off and back on, holding apple+ctrl+P+R, which worked. However, the next time I turned my computer on, the screen stayed white again, without an Apple logo. Can you tell me what the deal is? Should I bother reporting this to Apple? Is this permanent damage I'm going to have to go thru everytime I start me laptop? Any way to fix it? Thanks.
View 3 Replies View RelatedMy Mac book pro is not starting , it's just showing the white screen with apple logo
Info:
MacBook Pro (13-inch Early 2011), Mac OS X (10.7.3)
i tried to install snow leopard on my computer, but then found out it was only a one user disk and had already been used, so i started it back up on the hardrive and now it wont go past the white loading screen with the apple logo and then just shuts down. ive tried restarting in safe mode but thats about all i know how to do.
Info:
MacBook, Mac OS X (10.5.8)
i tried to install snow leopard on my computer, but then found out it was only a one user disk and had already been used, so i started it back up on the hardrive and now it wont go past the white loading screen with the apple logo and then just shuts down. ive tried restarting in safe mode but thats about all i know how to do.
Info:
MacBook, Mac OS X (10.5.8)
Whenever I shutdown or restart MBP 13 with latest OS X. I see white screen with spinning sign. It is never ending. Once I have kept it like this for more then 20 hrs. I have contacted Apple couple of times but the solution was not permanent. Please check video link to better understand my issue. [URL]
Info:
MacBook Pro (13-inch Late 2011), Mac OS X (10.7.2)
My computer won't turn on. Earlier today while playin music it just paused itself. I minute later it resumed. Then tonight it just shut off instead of sleeping and now it won't start. All I can get if I'm lucky is the start up chime and a super quick flash of a white screen.
Info:
MacBook Pro
How do I reset or reboot a first version of MacBook Air? It crashed when I tried to restart it and now just shows white screen with Apple Logo ?Â
Info:
MacBook Air, iOS 5
My step mom has an iMac. The first gen intel one and the other day out of nowhere there was a white screen with a folder on it and now when you go to start up the iMac the screen just stays white.. What would be the cause of this and what should I do to fix it .. thank you
View 21 Replies View RelatedHolding option doesn't work, taking out the battery doesn't work, running out of ideas.
Info:
MacBook, iOS 5.1.1
I have a Powerbook G4 with me and it doesn't boot up. I am suspecting it is hard disk/ software error that is stopping it from booting up. Here is what I see when I try to power it up: White screen, Apple logo with the round circle with rainbow color. Do you guys think that is is a software error that is stopping it from booting up? The last thing I did was to install Windows Messenger for Mac! I am thinking of trying to do a re-install using the disc that comes with my Powerbook purchase but I am at a lost of what to do. Can anyone please share with me the steps that I need to take? I've got a 'new' hard disk already, please advise on how can I rebuild my Powerbook!
View 1 Replies View RelatedCurrently im using the Windows XP partion on my Macbook which runs fine. But the Mac OS X will not start, it will stop running at the white screen with apple logo. I have tryed to re-install it from the disc but still not luck as it still stops at the apple logo. I have run several Hardware tests and its sais that there is no problems.
View 1 Replies View RelatedMy Macbook Pro is not starting past the grey screen and the apple logo and the rolling circle. I have tried every method and I am desperate to do anything to start my computer even erase the entire disc. I have contacted the Apple store and they told me the cost will be equivalent to $600 to just repair it and no way I will be able to afford it. I am willing to do anything and even erase my entire disc. However, for that the instructions on the Apple page state that 'Insert your Mac OS X 10.4 or 10.5 installation disc'. However, I do not have my installation disc Is there any other way I can erase the OS system and at least reboot my Macbook?
Info:
MacBook Pro
I have had my MacBook for almost two years and the battery had just died on me. So I sent it back to Apple and got a new one. But ever since switching over to this new battery, my computer has had issues starting up. A grey screen fades into white and the Apple logo never appears. The computer will just stay like that for hours. A friend suggested turning the power off and back on, holding apple+ctrl+P+R, which worked.However, the next time I turned my computer on, the screen stayed white again, without an Apple logo. Can you tell me what the deal is? Should I bother reporting this to Apple? Is this permanent damage I'm going to have to go thru everytime I start me laptop?
View 1 Replies View RelatedMy Mac mini won't move past a white screen with apple logo in the center. What should I do?
Info:
Mac mini
Power just went out and now our iMac ('11) wont restart. When I power on, the start up sound plays and then a white screen with the apple and an spinning circle underneath. After 10 mins, I shut it down and tried again.
Info:
iMac
My iMac will not start up, the apple comes up and the wheel goes round but then I am left with a blank white screen.
Info:
iMac, Mac OS X (10.6.8)
My MBP is looping on start-up. It goes to the white screen with the apple logo and that little wheel made of grey lines.
It just keeps spinning then after 30-60 seconds, it shuts down and restarts only do do the same thing again.
how I can fix this? I think I may have accidently deleted some system files. The last thing I was doing was deleting things from my Hard Drive.
My MacBook Air just started messing up yesterday and I'm not sure why? When I turn the power on, it will make the startup sound and go to the log in screen as it should but after my password is entered the screen goes white and it never loads.
Info:
MacBook Air
I just acquired a G4 MDD Power Mac. Dual 1 Ghz processors.I pulled the HD out of my older g4, connected it, and powered the machine up. The HD has OSX 10.5 and works fine in the older G4.
The first thing I notice is that the Small fan (in the door) is spinning, but the Large fan under the Power Supply is NOT. The red light on the Motherboard is on.
What happens is that all I get is a white screen, with the Apple Logo, and the spinning circle. it never acceses the hard drive and boots into 10.5 What does this point to? I hope the Dual processors are not the problem here. But that large fan not spinning worries me.
Why is my Snow Leopard OSX 10.6.8 IMac screen all white when I turn it on? There is no spiral and no Apple logo and the desktop does not appear. The screen is just white. Â
Prior to this, we had a wind storm in our area with some power glitches today. After one of them, the dock items disappeared and just the wallpaper was there. The colored spinner began going around when I clicked on the mouse but nothing was happening.  I unplugged it to try to reset it, but now the screen comes up all white, there's no apple logo that appears at start up and that's it. Now what should I do?
Info:
iMac, Mac OS X (10.6.8)
White screen on start up, doesn't boot.
Info:
MacBook Pro, Mac OS X (10.7.3)
I have a macbook intel core duo and it shut down in the middle of watching a youtube video. It will not startup freezes at grey screen with apple logo (no spinning disc). There are no abnormal sounds or extreme temperatures. The macbook is just over one year old.I have tried the following:Ran disk warrior 4 in target disc mode - no problems found
View 10 Replies View RelatedWhen i start the computer and the grey screen comes up with the apple logo etc., a grey "loading" bar has started appearing in the bottom of the screen. Takes a few minutes for it to go away. In the meantime the computer gets very hot and the fans are up to 6000 rpm. Then the os starts up, and I cannot download anything, due to the fact that it thinks my harddrive is full, though i have more than 100 gb of free space.I cant even download the 10.6.2 now due to the harddrive appears to be full
View 2 Replies View RelatedI tried to connect to a montor with a DVI connector but it's not getting a signal. Is there a quick fix? (School project today!!)
Info:
MacBook Pro, Mac OS X (10.6)
My 3-month old iMac was responding very slowly when I used the latest version of Safari. So I forced quit the program. From then on, whenever I turned on the iMac, it would get stuck at the Apple logo start up screen. I had to unplug the power since the machine is getting very hot after 15 mins.
View 3 Replies View RelatedThis situation began when I put my Imac on sleep. After, the screen turned on in black whit the cursor but I couldn't do anything.
Then to rebooted the machine, the apple logo and sound began fine but the screen turned off, so moving the mouse the screen turned on in black with cursor.Â
I'd tried many ways, resetting the PRAM, SMC, repairing the disk and permission, analyzing hardware, repairing fsck files.
Suddenly, when I entered in Verbose mode, mi imac brought into user choose screen and worked fine, but when I shut down and tried to start my mac in the next day, it didn´t work again.Â
Info:
iMac, OS X Mavericks (10.9.3)