My computer displays grey screen and apple logo for 10 minutes or more during start up and shut down. Sometimes it refuses to shut down. This issues started after installing OS lion. What do I do?
Info:
MacBook Air, Mac OS X (10.7.3)
So, today I tried to install windows through boot camp assistant on my mac. When it got to partitioning my drive I got an error that my hard drive needed repairing. So I opened up disk utility and clicked verify disk (I can't click repair) and got this error Disk Utility stopped verifying �Chris Hard Drive� because the following error was encountered: Filesystem verify or repair failed. I then researched this and learned to fix the problem I must boot from my leopard install disk and use the DU from their. Unfortunately I don't have access to the disk. But I have the install disk from my old macbook (the white one) so I used this. I put in the disk and shut down. When I turn it on I hold C but all I get is a grey screen but with out the apple logo. When I try turning it out holding alt I don't get the option of the CD just Chris Hard Drive. But when I boot up holding D i do get to the hardware test screen but I get the error that's something like "Hardware test does not support this hardware". Will the Leopard install of a different type of macbook not work on my new macbook pro (13" aluminium)?
View 1 Replies View RelatedI just bought a new 27" iMac and when I start it up I get a white progress bar under the apple logo. When it does come up, iTunes will not play and sometimes the computer will not recognize the magic mouse or my WiFi. Everything works fine after I re-start.
Info:
iMac, Mac OS X (10.7.4)
Unfortunately I bumped the switch on the power strip that my Mac Mini (1.42ghz G4, OS X 10.3) is plugged into while it was running. Now it won't boot up. All I get is the gray screen with the gray apple logo and the spinning wheel but no OSX.
View 14 Replies View RelatedI was installing the Mac OS X Snow Leopard (family pack), haven't installed yet, due to a moving from USA to Brazil. I put the CD on and followed the instructions of installation. After is ready to install, a message showed that would take about 1 hour and 45 minutes. So I left the room and when I came back the screen was bright with an "apple" on it, and its frozen, and I can't take the CD from the slot or do anything in the computer. What that means, did my laptop crashed? I did turn the power off and turn back on, but still the same.
Info:
Mac OS X (10.5.8)
Mac mini with 10.7 boots to grey screen with apple logo? Any way to overcome this?
Info:
Mac mini, Mac OS X (10.7.3), new machine
My 13" macbook is stuck on the grey opening screen with the apple logo and progress circle.
Info:
MacBook
Why is my Snow Leopard OSX 10.6.8 IMac screen all white when I turn it on? There is no spiral and no Apple logo and the desktop does not appear. The screen is just white. Â
Prior to this, we had a wind storm in our area with some power glitches today. After one of them, the dock items disappeared and just the wallpaper was there. The colored spinner began going around when I clicked on the mouse but nothing was happening.  I unplugged it to try to reset it, but now the screen comes up all white, there's no apple logo that appears at start up and that's it. Now what should I do?
Info:
iMac, Mac OS X (10.6.8)
My iMac is the latest model, however when I try to shut it down I get a grey screen with the apple loading spiral and it doesn't shutdown. I have version 10.7.4 OSX Lion, all updates have been downloaded. I have resorted to leaving it on. I do not want to hard shutdown because this could damage the system, my old iMac broke after the hard drive was damaged with the same style of issue.
Info:
iMac, Mac OS X (10.7.4)
I'm noticing some weird behavior in my Mac Pro first gen.
Basically, when I start it up, the displays just stays black for some time, until the Desktop loads up and the computer is functional, but never displays the gray screen with the Apple logo. This just happened all of a sudden and stayed like this.
I know is not a big deal now, but I'd like to sell it in the near future and this could be problematic for that.
I Have a MacBook pro 17" 2009 with OS 10.7 Lion, I was doing the updates in the middle of the updates give a error and say you need to restart, Now, when I restarted it is showing gray screen with apple logo and spinning gear and is not moving beyond that (even after 3 hours).I tried Resetting my mac PRAM and NVRAM, nothing, I tried Safe Mode, I tried verbose mode(command V) and is show me this,The system bootstrapper has crached: Trace/BPT trap: 5. I don't have originals cd I lose them when I move.and Lion I'm download from app store I don't Have DVDÂ I don't care about information on my mac, I backup everything daily. I just want to make it work again.
Info:
MacBook Pro, Mac OS X (10.7.3), 17" 2009
when i start up my macbook it goes the the gray screen with apple logo then the logo turns in to a circle with a line in it
Info:
MacBook
This morning, I would turn it on and it'd go to the grey screen with the Apple logo for a few seconds and then go to the icon that is a circle with a line through it. After reading online, I was able to boot it up in Safe Mode. I went to Startup Disk in Preferences. I chose the MAC OS X, xxxx and then clicked the lock to prevent further changes and then clicked restart. Now when I turn on the macbook, it goes to the grey screen with the Apple logo for at least two-three minutes and then just shuts off. Won't boot into Safe Mode now. I already tried the Command-Option-P-R keys trick like five times.
Info:
MacBook Pro
During boot Yosemite shows a grey screen with the Apple logo and a progress bar - is this normal?
Info:
iPad 2, iOS 7.0.3, 64 Ghz. 3G
I am trying to install windows 7 on macbook air, through an external DVD drive, since USB didnt work for me. The DVD is detected and ounce I click start windows installation, the system boots and gets stuck at the gray boot screen with the apple logo. What is causing this? how can I solve this?
View 22 Replies View RelatedFor several weeks, my black MacBook (2008) has been acting odd. Certain applications won't open, and when I attempt to open them, the computer makes a quiet clicking noise, like the drive is failing. Last week, when trying to boot it, the thing just wouldn't. Stuck on the grey Apple logo screen. Assuming a hard drive problem or failure, I ran the tests. I ran Disk Utility from the Snow Leopard install disk, checked & repaired permissions, checked & repaired disk. All okay. I ran the Apple Hardware Test from the install disk that came with the computer, using the test that runs for an hour or so, and all appears to be fine. The computer won't boot into safe mode. I've tried flashing the PRAM. I doubt I could achieve much through target disk mode, as I've already run Disk Utility. What's left to do? Something doesn't add up here.
View 1 Replies View RelatedMy Macbook Pro is not starting past the grey screen and the apple logo and the rolling circle. I have tried every method and I am desperate to do anything to start my computer even erase the entire disc. I have contacted the Apple store and they told me the cost will be equivalent to $600 to just repair it and no way I will be able to afford it. I am willing to do anything and even erase my entire disc. However, for that the instructions on the Apple page state that 'Insert your Mac OS X 10.4 or 10.5 installation disc'. However, I do not have my installation disc Is there any other way I can erase the OS system and at least reboot my Macbook?
Info:
MacBook Pro
IT does this every time, but when I do command and r or other such keyboard commands, it goes I the recovery pahe with no problem. Whenever I tried erasing the iMac to reset it, it said the disk was locked.
Info:
iMac, OS X Mountain Lion (10.8.5), April 2008 model
Upon start up my screen goes to normal gray w/apple logo and spinner then goes black. Cursor is visible and still is moveable but nothing else. I safe booted and bar came up also but then back to black screen.Â
Info:
iMac, Mavericks upgrade
I have a Rev A 12 inch Powerbook - 867 mHz, 640 RAM, 40 GB hard drive. The machine's always been reliable and has performed great over the years. I bought it the last week of July, 2003.
Yesterday, the Pbook was shut down, and I press the on button so it would boot up. Almost immediately, the hard drive makes a loud, whirring noise. The computer advances to the gray screen with the Apple logo, but it doesn't get past that point and the noise continues, as if it's a car engine that just won't start...
I'm going to take it to my local Apple Store in the morning, and hopefully the data, including my nearly 22 GB of music, can be saved. Any thoughts on how to get my computer working again? By the way, it's the original hard drive installed. Hopefully this is enough info to generate some ideas, I'm stumped.
I have had my MacBook for almost two years and the battery had just died on me. So I sent it back to Apple and got a new one. But ever since switching over to this new battery, my computer has had issues starting up. A grey screen fades into white and the Apple logo never appears. The computer will just stay like that for hours. A friend suggested turning the power off and back on, holding apple+ctrl+P+R, which worked. However, the next time I turned my computer on, the screen stayed white again, without an Apple logo. Can you tell me what the deal is? Should I bother reporting this to Apple? Is this permanent damage I'm going to have to go thru everytime I start me laptop? Any way to fix it? Thanks.
View 3 Replies View RelatedAfter recently doing a fresh install of Snow Leopard, it was working great for about a week, and now it hangs at boot and flashes the Apple Logo, a NO sign, and a folder sign. I booted in verboose mode and it say that it could not load drivers.
I had this problem before and I used Leopard's (10.5) Archive and Install feature to fix it.
Where is this located on SL (10.6) ? I DO NOT want to loose my data
iMac Intel G5 stuck at apple logo.
Info:
iMac, Mac OS X (10.6.8)
Macbook: A1181 Core 2 Duo 2.0ghz 1GB RAM
DVD disk: Leopard 10.5 Retail install
Hard drive: dead (spins with clicks).
With regular startup I get the flashing question mark and can hear the failed hard drive click and spin. After getting the DVD to boot in the drive (it doesn't suck it in right away), I get an apple logo and pinwheel like I should, but after about 30 seconds it goes to a black (blank) screen and the DVD spins down, but not all the way. The computer is still on, but nothing happens.
Oddities:
<>If I start it with an iMac 10.4 DVD I can boot to the install screen just fine, but can't install because it's an iMac DVD. I can erase and partition the drive fine (not the dead one, another one I have).
<>Safe mode boot does the same thing, but takes 20 times as long to boot
<>Retail OSX 10.4 DVD does not boot at all, but that one might be for PowerPC computers. I get the flashing question mark folder.
I forgot to switch on the power socket at the wall so when I came back it had powered off. When I switched it back on it showed the last screen visible before sleep mode kicked in and then showed the apple logo with a progress bar underneath. The progress bar starts to move slowly but after about a minute starts again. It slowly starts to move again but stops after about two minutes and the macbook powers off.
Info:
MacBook Pro, snow leopard
Pretty smooth sailing until I had to reboot my mac pro. It just stops at the point where you have the grey Apple logo and the spinner.
I just tried to upgrade my iMac to snow leopard (10.6.3) from cd.It remains stuck on the start page since hours : white page with grey apple logo and no spinning wheel or progression bar.Â
Info:
iMac
I recently noticed the Apple logo is magenta at start up, when it is centered on the screen, before it turns gray and moves up the screen to make room for login details. I cannot replicate the issue on restart but only see it when it starts up first thing in the morning. It literally flashes up for just a second or two then normalizes to gray.
Info:
MacBook Pro (Retina, Mid 2012), OS X Mavericks (10.9.3)
My wife's 1.67 ghz, 15" Powerbook G4, 10.5.8won't start up. It sticks at the grey Apple logo screen.I started with Command-V and got some text.The text that stood out was: "HFS Runtime corruption detected on Jodie [wife's account], fsck will be forced on next mount"Â
The last thing it said was:"Msg Order First]0 [Level 3] [Read U1D 0] [Facility com.apple.system.fs] [DevNode devfs] [Mount Pt/dev] [Path/dev/disk0s3] [FSLogMsgID 2104410583] [FSLogMsgOrder Last]
Info:
PowerBook, Mac OS X (10.5.8)
I just tried to update my 2008 Macbook from Leopard to Snow Leopard. Install went fine but all of the sudden I got an error message, accompanied big yellow triangle with a black exclamation mark telling me that the install has failed without any further info. I rebooted and Snow Leopard was trying to install again. I thought 'why not' and continued. Then, when I had to pick a disk to install on, my Macbook harddrive couldn't be found. I thought 'screw this I'll stick to Leopard' and rebooted. After that it just stuck on the grey screen with the Apple and the loading animation. How I can fix this or at least save my files?
View 3 Replies View Related
