Windows On Mac :: Formatting As Single OSX Volume (Removing Ubuntu Partition)
Jul 2, 2010
Now, I set up a partition to run Ubuntu on my MacBook, but now I want to remove that partition to make room for Windows XP. When I go to Boot Camp Assistant, I try to click 'Continue' but it gives me this: I thought I could fix the problem using Disk Utility, but I couldn't understand what I could do. I thought it would work by erasing them, but I may have made the problem worse. Here is what it looks like: I tried booting the Ubuntu disc as I read I could remove the partition using that, but I don't understand how that would work.
I know this isn't "Windows" per say, but I couldn't really find a closer forum to post in. I installed Ubuntu following their online guide using Bootcamp and such because I was curious. Now, it's not really working as much as I would like it to, and I'd like to remove the 90 or so Gigabytes I gave to Ubuntu in my partition.
I tried using the Disk Utility, and it always gets stuck on "preparing to remove partition". I waited for an hour and a half once, and it still had not progressed. I also tried using the Disk Utility off of my Mac OS X installation disk and saw the same failures and results. What can I do to remove this plaguing Ubuntu partition off of my hard drive for good?
Got my first MacBook Pro about 2 months ago and I have been enjoying it to full effect, installing programs such as logic studio and photoshop cs5 on it. Recently, however, I decided that I would like to access some of my windows based programs when I am on the road and don't have my desktop pc with me. So I bought a fresh copy of 32-bit Windows 7 Ultimate and sat at my macbook, put the disc in and then loaded up Boot Camp. I went through the menu options, decided that I wanted a 50GB partition, leaving my Mac OS drive at 182 GB with 83GB to spare. However, when I started partitioning, after about a minute it stopped and this error message appeared: "The startup disk cannot be partitioned or restored to a single partition. The startup disk must be formatted as a single Mac OS Extended (Journaled) volume or already partitioned by Boot Camp Assistant for installing Windows.".
I tried cleaning all my temporary files and deleting some files in my downloads that were quite large and I restarted my machine. The problem persisted. Is there a solution to this problem that does not involve doing all this rubbish with a fresh install of Mac OS? I don't have any method of backup apart from a couple of 4GB flash drives..
you cant use a windows xp sp1 disk to install windows xp onto your mac using bootcamp.What i wanted to know is if i partition my HD then format it to a recognizable format for windows installation disks, would i be able to install windows xp sp1 that way?or would the same principle apply as bootcamp and sp1 versions of xp are incapable of being installed on macs?
I just got my LaCie 1TB external HDD and I need to split it into two partitions, I need one to be Mac OS X, and one compatible with Windows XP, I assume that'll be Fat32 or NTFS.
IMac OS X 10.5.6 on 392.86 GB (392,855,289,856 bytes) of HD. 392.86 GB (392,855,289,856 bytes) of Windows Vista on what is left of original drive. My first action was to format the "Spare Disk" HFS+ which was successful but. The anomaly began once I removed the Bootcamp partition. I now have two drives which was once the original drive. The drive which had windows on now appears as "Spare Disk" when I view it through System Profiler but does not show up in the finder menu. It now appears as though the "Spare Disk" us useless and wasted space. My goal was to remove the BC partition and reunite the windows partition with the original. I'm not sure if I'm explaining this properly but simply put, I would like to connect the spare disk with the original disk so I have more usable space.
creating and then removing a Win7 partition, restoring the initial single-OSX partition layout does not have any impact on my OSX installation, right? There should be no risk for my OSX installation, but I want to have your confirmation before proceeding with the installation of Win7 on my MBP.
I would like to uninstall windows from my i-Mac and revert back to a single partition hardrive. Unfortunately I installed Windows about three years ago (never to use it really) and now when I go to uninstall in Mac OS X it says my Boot Camp beta has expired.
I want to make a clean reinstall of snow leopard without removing my bootcamp partition. Is it possible to do that and to continue using windows after the reinstall?
I've got a mac mini running SL and W7, but I only ever use W7 on it. Is it possible to have a single partition on it running only Windows 7? Is it even possible to boot from a Windows & install disk *without* going near boot camp? I ask because it's only a 320gb hdd and I'd like to maximise the disk space on it - this isn't a yawnsome debate of W7 v SL
I am trying to resize the bootcamp partition on my iMac. I opted for the 32gb option when I first ran bootcamp but I wanted to add more. I read online I could do this my shrinking the Mac HDD and then creating a new partition FAT32. Then open up windows and open up disk management. Then right click my bootcamp hdd and click "extend volume." however, that option is greyed out. Am I missing something or is there some other technique?
In copying a list in nested-table formatting on the Internet to Word, I find that I can't clear the formatting or convert the table to text. How can I remove the nested-table formatting? I don't want to have to copy and paste each item.
I recently decided to increase the volume of my bootcamp disk, which I had done in the past using a method which ultimately made the disk unrecognizable. This time around I used Winclone to create an image of my bootcamp disk. I was not sure exactly how Winclone worked and to be safe I decided to keep the Bootcamp disk I had, and I created a third partition of a larger volume to which I restored the bootcamp image. Everything worked fine obviously, and the image was restored correctly to the new larger volume. The dilemma is I had two bootcamp disks, so I erased the smaller volume because I no longer needed it. Currently I am trying to restore this empty space within the main disk to the Macintosh HD. Disk util looks like:
I know I can just create a backup of the macintosh HD, another image of the bootcamp disk, and format the disk and start over, but I am hoping there is an easier way to go about this; considering there has been a method engineered such that I can just drag that corner of the mac HD and voila I have instantly more storage after applying, it seems viable that there is something that can be done rather than formatting my disk, unless the necessity for that of course was overlooked.
Info: MacBook Pro (13-inch Mid 2012), OS X Mavericks (10.9.4)
I just installed Ubuntu 9.04 onto a small 10GB partition that I quickly made in Disk Utility (resized my HFS+ partition while leaving my Windows 7 one intact). Upon reboot, I hold Option, and it only shows the 2 partitions (OS X & Windows). I was hoping it would show the Ubuntu partition. Since it doesn't, I have to use the Windows 7 bootloader to boot into Ubuntu. So, is there a way to edit my MacBook's bootloader to show all 3 partitions?
I am new to Mac. I bought a new MB Unibody. I have been learning little by little day by day. I wanted to see if I could install Ubuntu v8.10 on a partition and go dual boot with it. I only used a 5 gb partition. Now when I start up t goes right to Ubuntu. I have been hitting the C button to change back to OSX. My Question is, Did I screw up and not install it right? Can I go back to default settings? Is it just a button i am missing to go back to OSX? I would love to go back to OSX. I just wanted it as a dual boot.
I have Ubuntu 9.10 (Karmic) installed on my MacBook Pro 3,1 as well as Mac OS 10.6 (Snow Leopard). Is there a way to set the startup disk as the Ubuntu partition (ext3) so that I don't have to hold option or use rEFIt?
I wiped out my hfs+ partition (don't ask me how, suffice it to say that me, the computer nerd, made a STUPID mistake). I have my Tiger install disc. I need SOME way (possibly from a Windows partition?) to format only a SINGLE partition to hfs+ (I already have the unallocated space ready to be formatted) without losing any other data, as I no longer have a way to re-install Windows if I wipe it out, and I need Windows (I just don't want to ONLY have Windows!)
I need to install leopard onto my laptop using a disc image and need to create a partition on my FW drive. I heard leopard can do this with out formatting.
if i can partition my Windows NFTS External Hard Drive. I do not want to format it because i have some important files and programs on my External Hard drive, But I also want to use it for Time Machine Backup. I was wondering if it was possible to Not format my Hard drive, Partition it, And then format the 2nd partition to Mac, and use it for time machine. I am using Mac OS X Leopard 10.5.8
The Capacity of the EHD is 55.9GB Available: 37.1GB Used: 18.8GB
I've been backing up my Powerbook G4 for a few months using Time Machine to an external firewire drive with two partitions; one for the backups, and a much larger one for all my music, video, pictures, etc. I got a new mac mini over the weekend and I want to format the Time Machine partition without erasing the one with all my other files so I can start backing up the Mini.
I have a 250GB firewire drive. I have a G5 iMac and an Intel iMac. I'd like to make bootable clones (about 60GB each) of each for off site backup, so two logical partitions. As far as I can see, the partition table scheme is determined at the physical drive level. But I need the logical drives to be Apple for the G5 partition and GUID for the Intel partition (please correct me if I am wrong) in order for them to be bootable. Is there any way around this, or do I need two physical drives after all?
I frequently have to repartition my drive and reinstall OS X (mainly because I work with multiple OSes that keep changing). In order to simplify the process, I'd like to create a disk image of my system partition that I can simply restore after repartitioning. However, is that even going to work if the new partition (the destination partition) has a different size and is at a different place? What about the boot sector? Will I be able to boot from the restored image?
I currently have a small partition on my 27' imac allocated to Bootcamp which I now no longer require. I would like to remove this partition and restore the complete drive back to OSX without losing any vital info. Yes, I have done research on this however I remain a little confused. I would be grateful if someone would take the trouble to confirm that this is possible and, if they have the time, write a simple step by step procedure for me.
Ive lost Hd space after removing my windows partition (60gb). I can't reinstall another partition as I've only 23gb left... when removing the original partition it came up with an error (can't remember exactly..but it failed to verify?
I tried using disk utility to open up the disk size, by streching the corner mark?? and verify it, as per a previous recommended remedy ..it fails
I have re opened osx in R mode and used disk utility it still fails to repair or verify lost space? I have no back up drive as it recently failed...tsk and don't want to lose anything else??
Before I get flamed and etc... I have google and done some research about this issue but cannot find much about it.
I am not sure if this is a very common issue or topic but how do you adjust or modify your apple keyboard so that you can adjust screen brightness or volume? I am currently running Windows XP SP3, on a 2.4Ghz Unibody Macbook.
As soon as I start the Bootcamp assistant I get this message on the screen that asks for download of the windows support files - ie right at the start.The startup disk cannot be partitioned or restored to a single partition. The startup disk must be formatted as a single Mac OS Extended (Journaled) volume or already partitioned by Boot Camp Assistant for installing Windows.
Is it possible to reformat a single partition of a disk w/o reformatting the entire disk?Or must one reformat the entire disk? In DU, If I click on the volume/partition in question, I do NOT get the tab “Partition.” If I click on the disk, not just the volume/partition in question , then I do get the tab “Partition.” Also, does using DU to secure erase a volume by overwriting with 0s, cause a format issue? Some details on my other post:Create a bootable clone using Disk Utility
Info: iMac, OS X Mavericks (10.9.4), 4 GB RAM, Win XP Pro-Boot Camp
I want to clean install windows 7 after formatting disk. This doesn't sound like a great idea, but I need this for couple of engineering softwares to work. I don't want to spend my nights in computer cluster or at friends pc...
I have heard, I will encounter following issues: - battery will drain faster - graphics driver for x64-bit version - camera - iPhone backups and syncs (music, video, cal, contacts and apps) - I would need a external mouse for right click.
I can live with all of the above problems except graphics card drivers. Can anyone provide feedback or useful links they have refered to installing Windows 7?
