MacBook :: Running On Reserve, And It Will Go To Sleep In A Few Minutes?
Sep 8, 2009
So I got a new White MacBook a few weeks ago, and it isn't sleeping properly. When Im using it and the battery gets low, I get the message that it is running on reserve, and It will go to sleep in a few minutes.I keep using it, and turns off, but the light stays on solid for about 10 seconds while it is copying the RAM to the HD for the "Deep Sleep." Then it just turns off instead of breathing. To wake it back up again I have to plug it in and press the power button. I was under the impression that it is supposed to enter normal sleep (I.E. the same as when you close the lid) when the battery gets low, and only enter "Deep Sleep" if it stays asleep too long and the battery dies completely.
View 6 Replies
ADVERTISEMENT
Mar 12, 2012
why my MacBook goes on reserve battery so soon? I just charged it now I see for 43 minutes and pretty soon I have to charge it again...
Info:
MacBook, Mac OS X (10.5.8)
View 7 Replies
View Related
Aug 19, 2009
How often do you run on reserve power? I do it everyday and am running on it right now =D
View 3 Replies
View Related
Jun 18, 2010
I just turned on my 13" MBP and got this message. Apparently, this is supposed to come up when there is only like 5% charge left. My battery indicator at the top of the screen said there was 22% charge left. Also, according to IStat, my battery's health has already dropped down to 97% after only about 2 weeks and 5 cycles. Is this normal? I'm going to try recallibrating my battery by fully charging it and then letting it fully drain. Is there a good chance that this solves this problem?
View 1 Replies
View Related
Nov 6, 2010
Yesterday, I had some issues with my MacBook Pro, the keyboard and trackpad were unresponsive (I tried a USB Keyboard/Mouse, didn't fix the problem), it took 10+ minutes to boot up, and it refused to wake from sleep. So I did some hunting, found out if I removed the FireWire kexts, then that would solve the issue. I removed the kexts, and rebooted it, and everything works perfectly fine, with one exception. Both FireWire ports are undetected and inoperable. Would a OS reinstall fix this, or is it some deeper issue that may require a logicboard/hardware component replacement?
View 1 Replies
View Related
Jun 3, 2014
I have a problem with my Mid-2012 non-Retina MBP. When I close the lid, it takes around 4 minutes for the light indicator to dim and it's not safe to move the machine as it's probably doing something and it's HDD is probably still spinning. It's not like this for my friend's machine, even though it's an older machine.
Info:
MacBook Pro, OS X Mountain Lion (10.8.4)
View 1 Replies
View Related
May 4, 2012
2 days ago my computer stopped being usable. It is the slowest thing ever now. Spinning wheel all day long. Takes 8 or 9 minutes to restart... Crazy lag time even opening a finder window. NEVER ran slow before. No new software installed...
Info:
MacBook Pro (13-inch Mid 2010), Mac OS X (10.7.3)
View 3 Replies
View Related
Jun 2, 2014
This is driving me crazy. I have tried so many fixes but nothing has worked. Every time I hibernate / sleep my 2012 macbook air, the wifi drops and takes at least 20 minutes to come back on when I open the laptop again.
I can reboot, turn the wifi off and on, change preferences...everything. Nothing works.
Info:
MacBook Air, OS X Mavericks (10.9.3)
View 4 Replies
View Related
Apr 18, 2012
Running Lion on a Core 2 Duo 2 GB MacBook. It is taking about 3 and a half minutes to start-up. This is happening only recently.
Info:
MacBook (13-inch Aluminum Late 2008), Mac OS X (10.7.3)
View 3 Replies
View Related
May 15, 2012
A few days ago, I found my macbook running slow. The starting time used to be 2+ min but slow down to 10+ min. I tried to reinstal by installation DVD but the time bar showed 5+ hours required. I restarted the macbook and tried to format the HD, after proper steps taken, the time bar showed 17 days. Instead booting from the system, I tried to boot direct from my installation DVD.
After formatted the HD and re-instal the system, the MacBook seems running smooth again. But after installation of other programs, the same problem recurred. The system was getting slow. Re-starting it required waiting over 10 minutes. I tried to re-format the HD and installed the system again but still doesn't work. Under the disk utility "first aid" scanning through the HD, it showed "Invalid key length." and "The volume Macintosh HD could not be verified completely."
Info:
MacBook, Mac OS X (10.6.8)
View 4 Replies
View Related
Mar 23, 2010
I have a MacBook (2 GHz, 2GB RAM) OSX 10.6.2. The problem that I have with it is that I will not tell me when it is on reserve battery, so I shuts down with out me knowing. The computer has reported that the battery needs to be replaced soon, but I can't see how that would affect the battery notification. Also all of the energy preferences have been set back to default so there is nothing in the preferences that would be affecting this.
View 3 Replies
View Related
Aug 24, 2014
I have this MBP 13'' Mac OS X 10.7.5 running a 2.4GHz i5, 4GB RAMs and 500GB storage.The problem started yesterday when I was typing on Word and I copy pasted something from the net (chrome browser) then it froze.I waited for around 5minutes and still frozen with the spinning wheel, then I decided to turn it off by pressing power for 10 seconds restarted my
MBP then now it running so slow on start-up and apps are very slow to open like around 5 minutes. Every action that I try to do like clicking on the apple in the upper left it freezes showing a spinning wheel and it will take time to show the drop down options. I checked disk utility and it said that HD is ok, done verify/permission verify and repair.
I checked the activity monitor noting the ram/CPU usage and its normal it even tells that 2GB of ram is not use.It shows not responding in the activity monitor if you open an app for around 5mins then it opens or it will crash.I already done the 2 kinds of reset and did not work.BUT it opens normally in Safe mode.
Info:
MacBook Pro, Mac OS X (10.7.5)
View 5 Replies
View Related
Sep 11, 2014
Every since I upgraded my OS to 10.9, my performance has been going downhill. Now, even though I have reformatted my hard drive and have not even put any new data on it, it takes 45 minutes to restart and 25 minutes for me to open the window to write this message. Below is my system info. Why my system seems to have slowed down so much. You can see there is nothing on the hard drive to slow it down.
View 8 Replies
View Related
Mar 31, 2012
My new macbook air is 10.7.3 s running hot, with the fan blowing after about one hour on the internet. It will also run very hot with the fan blowing when it is closed and in sleep mode, is this normal? My macbook pro did not do this.
View 3 Replies
View Related
Jul 1, 2010
I'm running Windows 7 with boot camp on my unibody MacBook Pro.
Quite often, I'll close the lid to put it to sleep, then, a few minutes later I'll notice that the Apple light has turned on, and when I open the lid I confirm that it's woken up.
In Event Viewer, I've noticed that every time this happens, the following event is listed, in the Power-Troubleshooter category: "Wake Source: Device -USB Composite Device".
I have no USB devices, ExpressCards, CDs, or anything plugged in.
EDIT: It doesn't only happen when it's running on battery power, since it just happened with the AC adapter in.
View 5 Replies
View Related
Nov 17, 2007
Last night I was putting my macbook to sleep while I was ni the other room, and came back only to hear the fan or hard drive going 100 miles per hour it seemed, so I opened it to see if anything was active and nothing was it was just making a ton of noise. Any one know what it coulda of been? No software update was taking place?
View 15 Replies
View Related
Aug 29, 2014
My macbook onward restart when waking up from sleep, but no error message appear . Plus all my program and website reload back as before. Only problem is why it restart occasionally and it is normal. I don't have that symptom on earlier. Now using maverick 10.9.2
View 1 Replies
View Related
Mar 20, 2009
I have set it (10.5.6) to sleep after 1 minute, but it never goes to sleep. No External drives attached, iTunes sharing turned off etc. Though I never needed to turn off sharing of any kind before to get it too sleep.
View 2 Replies
View Related
Nov 23, 2007
My old G5 dual 1.6 will not go into sleep mode. I had upgraded to 10.5 but several of my photography programs would not run so I reverted back to 10.4 by reinstalling the operating system and not wiping the drive clean. I now must shut down everytime or the G5 will get to the point that all of the cooling fans are running full speed and it will not go into sleep mode automatically. Any suggestions other than a clean install?
Information:
G5 dual 1.6
Mac OS X (10.4.11)
View 3 Replies
View Related
Oct 30, 2010
Maybe this is a dumb question, but it seems on my system if the screensaver runs then the monitor sleeps, the screensaver is still running when i go to wake the monitor. does that mean its been running the whole time wasting cpu cycles and drawing more power than is necessary? you'd think it would stop.
View 1 Replies
View Related
Jul 4, 2009
Everytime my MacPro goes into sleep mode (either from activity for from me manually putting it there) it immediately clicks awake. Strangely, when I'm booted into Vista, it sleeps like a baby. Is there a way to figure out what is triggering this? I have a few wireless devices plugged in (mouse, keyboard, display) and bluetooth is off (I'd read that bluetooth headsets are a common culprit).
View 8 Replies
View Related
Nov 15, 2009
I've been looking for a way to run a script or application every time my Mac wakes up from sleep. However it's proving to be surprisingly difficult.
The only option I seem to be able to find is SleepWatcher, which runs from the command line, I guess, and I can't seem to find any documentation on it. Well, at least none that actually gets it working. If anybody can tell me how to get it working, that'd be great too.
View 2 Replies
View Related
May 6, 2012
We have Imac Intel Mac OS X version 10.7.3. When I put to sleep the screen goes to but no the hard disk.
From the console I get the following message.
06/05/12 20:34:16,805 [0x0-0x19019].com.elgato.eyetvhelper: ***Wakein::CancelEvents: requested event type: wakepoweron06/05/12 20:34:16,805 [0x0-0x19019].com.elgato.eyetvhelper: ***Wakein::CancelEvents: requested app name: com.elgato.eyetv06/05/12 20:34:16,806 [0x0-0x19019].com.elgato.eyetvhelper: ***Wakein:
0 entries in power event schedule table I have Eye TV program install since 3 years ago, I can see it stops the sleep mode, I have look at preferences of Eye Tv but can not find anything that says not to put the Mac to sleep! I have had this problem for the last 2 weeks and before there was no problem at all.
Info:
iMac, Mac OS X (10.5.8)
View 5 Replies
View Related
Feb 8, 2007
I have a MacPro 2.66 quad-core intel. 4gb ram. I have a hard-drive from my old Powermac that i upgraded to 10.5.5 for this computer. Everytime I put my computer to sleep, and then wake it back up. The fans spin up to maximum speed and all the fans are running really loud and then after about a minute all spin to normal speed.
I don't have any other flaws except for this. Why could this be?
View 1 Replies
View Related
Jun 28, 2009
I noticed that something was running in the background when I . I checked activity monitor to see what was running and saw that a process named "Find" user name "Nobody" was running. It disappeared before I could inspect it. Does anybody know what process this is and what application may be running it? I'm now paranoid!
View 2 Replies
View Related
Jan 26, 2009
i'm chearching an Applescript to sleep the display on my iBook running Tiger. I visited allready all the dutch apple forums but I didn't find, so if someone can give me an easy applescript?
View 4 Replies
View Related
Apr 9, 2008
I leave my Air on pretty much all the time, and put it to sleep while moving around etc. Sleeping it disconnect the Airport connection - which if very annoying. At a desk I've just been dimming the display all the way off in order to keep my connection.
However, I recently noticed that by setting a "sleep display" hot corner, my network connection is maintained.
I have 2 questions:
1) Is sleep display equivalent (functionally) to simply dimming the display all the way down?
2) Is there a way to either set up a shortcut to sleep the display (other than a hot corner) and/or set it so that only the DISPLAY sleeps after 'x' minutes?
View 4 Replies
View Related
Oct 10, 2009
I set the MBP to sleep in 10 min through the Energy Saver pref with the option to sleep the hdds. When it's about to sleep the screen dims, then turns black, then the sleep light comes on but does not blink no matter how long I leave it. The blinking only happens when I close the lid or when I select the Sleep option under the Apple logo. Is that normal behavior?
View 11 Replies
View Related
Dec 11, 2014
I have a macbook pro 13" early 2011 and I'm se as shown in the pictures (since i upgraded to os x yosemite) . It happens after display sleep or computer sleep on login not on boot up .I've noticed that i run out of ram when the problem appears (only 15MB RAM available out of 4GB), though i doesn't happen every time . I've talked to service and told me its either motherboard replacement or because the ram isn't enough (gpu shares with main ram) so maybe i should try upgrading ram. URL....
Info:
MacBook Pro, Mac OS X (10.6.8)
View 1 Replies
View Related
Jul 12, 2009
I have torrents going all the time. If the computer goes to sleep, the internet disconnects, so they stop. Display sleep wouldn't disconnect though. Is it OK to have computer sleep on "never" but keep display on "15 minutes"? I don't usually even leave the computer on overnight.
View 3 Replies
View Related
