My 3 month old macbook pro suddenly has problems booting up. I press power and it goes to the gray screen with the apple logo, the gears start spinning, and then it just shuts off!
Info:
MacBook Pro, Mac OS X (10.7.5)
13” MacBook Air laptop boots to a gray screen
Info:
MacBook Air, Windows 8
having problems with my MacBook Pro. Turns on, straight into user log in. Once password is entered it tries to start up then eventually after grey progress bar has finished brings up a grey screen, then shuts down again.
I've tried starting in safe mode and resetting PRAM etc with no success.
Info:
MacBook Pro, Mac OS X (10.7.2)
I did a search but I would like to know why occasionally my 1.8 single G5 fully updated 10.4 boots up to a grey screen with a prompt> message says
to either type mac-boot (does not work) or shut-down (does work)
It happened at any stage since I bought it (second user) years ago since panther 10.3.. It even happens after repair and verify is checked.
It gets a lot of use maybe 6 hours a day so am I about to meet thy doom?
I can usually press the power button and boots ok but recently 2-3 times
to get going
I am considering getting more ram and leopard and want to find out whats causing this issue first?
I'm running 10.6.8 and yesterday I noticed my ipod not connecting to my computer at all. So I did a software update and restarted my computer. I don't remember what the install was because I've done this procedure before. But this time my computer restarted but held on the grey apple icon spinning wheel screen. I had to power down after several minutes. I've booted up from an bootable archived system and ran diagnostics on the directory using Disc Utilities & Disk Warrior. Directories were fixed. When I choose the main startup hardrive, same thing occurs.
Info:
Mac Pro, Mac OS X (10.6.8), 2 x 2.66 GHz Dual-Core Intel Xeon
Well I have managed to get the g5 tower dual 2.5ghz to boot up to the grey screen with the apple logo then it shuts itself down.
View 1 Replies View RelatedI put a new hard drive into my iMac 24". I could not install OS X because every time I turned the machine on it would shut down in less than a minute at the grey screen and Apple logo - whether the disk was in the slot or not. I finally was able to install Snow Leopard via firewire from a Macbook Pro. It runs fine - but I can only access the iMac Snow Leopard installation from the Macbook Pro. When I turn on the iMac, it still shuts down every time. The new drive was formatted with the Disk Utility as an external drive - since I couldn't get to it while it was in the iMac. My Snow Leopard disk was a full version, not an upgrade.
Info:
iMac, Mac OS X (10.6.8)
When waking from "sleep" the screen appears normal but, the pointer leaves a trail of grey as it moves and the whole screen will turn grey if I keep moving the pointer. The computer is effectively dead. Have to shut down by using power off for six seconds and then re-starting. I know little about computers!
Info:
MacBook Pro, Mac OS X (10.7.3)
i am using mail v 3.5 and when i try and erase anything from my inbox it just turns grey... then i click out of it and it's still there. does anyone know how to fix? I have tried everyting on this site (apple support)
View 13 Replies View RelatedA few days ago my macbook froze, when I did a hard reboot it boots to bluescreen. I've even left it up overnight just in case it was talking awhile.
Here is what I've tried so far:
-boot into safemode, holding in shift does nothing.
-Tried to run disk utility, it said something like it couldn't be done (forgot the exact message)
-reinstall the OS from cd, but holding in c causes it to reboot.
-holding option and clicking the cd to boot from causes a reboot also
-command-option-shift-delete does nothing
-Gone into single user mode done the fsck thing, also tried this [URL]
Starting to think the HDD is shot. Just noticed an error when I type in /sbin/fsck -fy it says "Incorrect block count for file pcscd.pub it should be 16 instead of 17. Not sure if that means anything. Was able to run disk utility now, no errors were found however it still will only boot to blue screen.
Just about 2 hour ago I put my mac on standby because I had to do some homework, but after I finished my work and opened up my computer, the screen was black. I then resetted the computer by holding the power button down but still nothing.
The computer makes all the sounds like it normally does, it does the chime aswell. However, when I close the computer up the front light isn't pulsating, its just glowing. While my computer's screen is black I can adjust the sound (it makes the noises) and I can adjust the backlit keyboard brightness, but it doesnt respond to trying to light up the desktop. I've tried to shine a light to the desktop but can't see anything.
I've tried looking at some similar posts, tried to reset it up by holding cmd+opt+p+r.. nothing works. I can't understand this... it was working just fine only hours ago
EDIT: after leaving it for 10 minutes, the front light started pulsating as normal again, but when I open it up, black screen still.
So I have a DYNEX 21 inch HD TV conected up to my MBP via the VGA connection route. My problem is that when I want a program (or more specifically in this case a game) to go into fullscreen mode it automatically goes to my primary monitor and turns the other screen black. I know I can switch the primary monitor from my actual laptop screen to the TV however I just want the game to be full screen on the TV while still having access to my dock and everything on my laptop.
View 2 Replies View RelatedI left my laptop on in my room while I went to the bathroom, and when I came out, I saw the message that told me I must restart the computer. The message froze the computer, so I shut it off by holding the power button and tried to turn it back on again, but it only boots to a black screen. I don't hear the loud hard drive noise, but I hear the fans. Without AC power but with the charged battery, the computer shuts down after a few seconds. The light on the button that opens the lid is dim-to-none when the lid is open and bright when the lid is closed.
I tried many troubleshooting methods discussed on this site, like removing and reseating the RAM and draining the battery, along with the things that the Apple website suggested, like resetting the SMC and PRAM, but nothing works.
I brought the computer into an Apple Store, and after the NVIDIA test was negative, the technician told me that the problem is most likely the logic board. I also took the computer into an Apple Authorized Service Provider, and the technician there said it could be the logic board, hard drive, or boot connector. He also said that there is a very slight chance that the graphics card could have caused the logic board to fail. He tried my computer with another battery and concluded that it's not the battery's fault.
The Apple Store is charging me about $330 for a flat-rate repair. Should I troubleshoot further using suggestions you may have or pay Apple for repairs? If I decide to have Apple repair my laptop, do I need to take it back into the store to pay the repair charges, or can I do it over the phone and mail the computer to Apple?
My MBPro, OSX 10.4.11 boots up to frozen blue screen with little pixelated squares.
Info:MacBookPro, Mac OS X (10.4.11)
macbook pro with latest software update, retina, boots up to a gray screen. The appearance of a screen opening up after the apple disappears with a border opens to another gray screen.
Info:
MacBook Pro (Retina, 15-inch, Early 2013), iOS 7.1.2
grey screen no apple followed by blue screen with vertical lines. Graphics and logic board replaced <6 months ago. What to do? I held down shift, it gets HOT HOT and makes noises. (for safety mode) followed by a blank grey screen and blue screen. Then tried the other way (I think it's command alt delete? I don't remember) and it turned from grey (no apple symbol) to blue blank. Then third time, grey followed by blue with vertical lines, not blocky clear lines that you can see if you are close to it.
Info:
MacBook Pro, OS Lion
I am trying to install windows 7 on macbook air, through an external DVD drive, since USB didnt work for me. The DVD is detected and ounce I click start windows installation, the system boots and gets stuck at the gray boot screen with the apple logo. What is causing this? how can I solve this?
View 22 Replies View RelatedHolding option doesn't work, taking out the battery doesn't work, running out of ideas.
Info:
MacBook, iOS 5.1.1
At least, it seemingly randomly turns off. I can be surfing the web or whatever like normal, but then after a period of time the monitor goes black. I can see that the computer hasn't shut off, but it's as though the computer is on its lowest brightness setting. It can be temporarily fixed some times if I lower the brightness all the way via F1, then put it back up, but if it goes up more than 3 or 4 boxes it goes black again.
It also goes black if I were to move the monitor any time during this whole thing. I've heard things like an inverter cable and board, but I have no idea what's going to fix this. This is my only computer, I use it for all my school work, if it breaks permanently I'm screwed.
I just bought a refurbished macbook pro and at first the screen wouldn't turn on when I started it up, the little sleep light was on though. I pressed and held down a key for a few seconds right after pressing the power button and the screen worked. My question is, should I be worried about this? I got the computer from a company I later found out is really difficult to deal with so I don't want to have to return or exchange it, but I also want to get my moneys worth.
View 2 Replies View RelatedIt happens every now and then that the display light of my MBP late 2011 turns off right after opening it and I only can get it back by hitting F1 and F2.
Info:
MacBook Pro, Mac OS X (10.7.3)
After turning machine on I can hear it powering up but the screen is blank...I can see the little white light on the right lit up!
Info:MacBook, Mac OS X (10.5.2)
I've installed OSX successfully many times but this one, with a new WD disk gives me trouble. After the gray screen is gone and the installation menu starts, the back-light turns off and I can't do anything about it. Any idea why that happens and how I can deal with it? I am working on a Mid 2009 13" Macbook pro with 2.26ghz and 8GB of RAM.
View 5 Replies View RelatedMacbook is charged up. Sounds like it's turning on but no tone. Screen stays black.
Info:
MacBook, Mac OS X (10.7.3)
There is also no display when hooked up to external monitor. No display when started in safe mode. No display when started with PRAM reset either.
Info:
MacBook Pro (15-inch 2.4/2.2 GHz), Mac OS X (10.5.8)
Mac pro has a gray screen with apple logo running pinwheel but wont load up. Tried shutting it down and restarting a couple of times with no success
Info:
MacBook Pro
I can hear the chime going off, but the display turns on you cannot see through naked eye, you have flash light onto to the screen to see very little, can you tell me why this is happening and how to fix this issue. Secondly, can you tell me how to fix this issue, my keyboard and trackpad doesn't work. Is it the problem of flex cable of both the keyboard and trackpad or is the related to software
Info:
MacBook Pro, OS X Mavericks (10.9.4)
My macbook pro late 2009 (10.6.7) when i press the power button it turns on, then it turns off by itself and then on again and gets a black screen and nothing more no booting sound and i just hear the fans or the Hard Drive going...
Info:
MacBook Pro, Mac OS X (10.6.7)
my computer turns on but there is only a black screen. i hear the sounds and am able to press buttons but nothing is seen. how to I fix this?
Info:
MacBook Air, OS X Mountain Lion (10.8)
My mac book pro seems to turn on and load with a dim screen, but turns off after that. I've tried the shift method but it still doesn't work ...
Info:
MacBook Pro
