MacBook Pro :: Turn On And Load With Dim Screen But Then Turns Off
Jun 4, 2014My mac book pro seems to turn on and load with a dim screen, but turns off after that. I've tried the shift method but it still doesn't work ...
Info:
MacBook Pro
My mac book pro seems to turn on and load with a dim screen, but turns off after that. I've tried the shift method but it still doesn't work ...
Info:
MacBook Pro
My screen is black but my laptop is not off.. and its not that only the screen is black, my mac on sleep (i think)...When I turn my mac on, it does turn on.. The starting screen comes out.. but the moment the desktop opens, the screen goes black. And if I try to wake my mac up by pressing any key, the mouse shows for like three seconds(on the black screen, not my desktop). So that means that my mac is not totally off, it's just that the screen is black. But once in a while, when I press any button, my desktop shows for five seconds and the screen turns black again. I had yesterday was that the finder was keep restarting. I was still able to go on all the apps except that I could not open any files on my desktop.
View 1 Replies View RelatedMy MacBook Pro is turning on to startup screen with apple icon and loading signal, but then after a few minutes the screen just turns white. What is wrong?
View 1 Replies View RelatedI recently had my screen replaced because of a crack. Now I find when I open the laptop to use, after being on sleep mode. It momentarily turns blue, sort of flashes/glitches then works normally. Should I be concerned?
Info:
MacBook Pro with Retina display
I put a new hard drive into my iMac 24". I could not install OS X because every time I turned the machine on it would shut down in less than a minute at the grey screen and Apple logo - whether the disk was in the slot or not. I finally was able to install Snow Leopard via firewire from a Macbook Pro. It runs fine - but I can only access the iMac Snow Leopard installation from the Macbook Pro. When I turn on the iMac, it still shuts down every time. The new drive was formatted with the Disk Utility as an external drive - since I couldn't get to it while it was in the iMac. My Snow Leopard disk was a full version, not an upgrade.
Info:
iMac, Mac OS X (10.6.8)
Why airport turns off and I need to restart MacBook to turn on again?
View 1 Replies View RelatedMy airport/wireless works fine most of the time, but sometimes when I close the lid, and reopen it, my airport will not turn back on. It turns on neither automatically nor through the preference pane. The button to turn airport on is clickable, but nothing happens.
I'm new to Macs, and I like them so far. But this is getting really annoying as the only way I've found to fix it is to restart the computer.
So I have a DYNEX 21 inch HD TV conected up to my MBP via the VGA connection route. My problem is that when I want a program (or more specifically in this case a game) to go into fullscreen mode it automatically goes to my primary monitor and turns the other screen black. I know I can switch the primary monitor from my actual laptop screen to the TV however I just want the game to be full screen on the TV while still having access to my dock and everything on my laptop.
View 2 Replies View RelatedTurned on my MBP and all i get is a grey screen, OS doesnt load just a grey screen.
View 1 Replies View RelatedI've tried turning it ff and on via the power button several times, but it always goes back to the white screen.
Info:
MacBook Pro (13-inch Mid 2010)
At least, it seemingly randomly turns off. I can be surfing the web or whatever like normal, but then after a period of time the monitor goes black. I can see that the computer hasn't shut off, but it's as though the computer is on its lowest brightness setting. It can be temporarily fixed some times if I lower the brightness all the way via F1, then put it back up, but if it goes up more than 3 or 4 boxes it goes black again.
It also goes black if I were to move the monitor any time during this whole thing. I've heard things like an inverter cable and board, but I have no idea what's going to fix this. This is my only computer, I use it for all my school work, if it breaks permanently I'm screwed.
I just bought a refurbished macbook pro and at first the screen wouldn't turn on when I started it up, the little sleep light was on though. I pressed and held down a key for a few seconds right after pressing the power button and the screen worked. My question is, should I be worried about this? I got the computer from a company I later found out is really difficult to deal with so I don't want to have to return or exchange it, but I also want to get my moneys worth.
View 2 Replies View RelatedIt happens every now and then that the display light of my MBP late 2011 turns off right after opening it and I only can get it back by hitting F1 and F2.
Info:
MacBook Pro, Mac OS X (10.7.3)
After turning machine on I can hear it powering up but the screen is blank...I can see the little white light on the right lit up!
Info:MacBook, Mac OS X (10.5.2)
I've installed OSX successfully many times but this one, with a new WD disk gives me trouble. After the gray screen is gone and the installation menu starts, the back-light turns off and I can't do anything about it. Any idea why that happens and how I can deal with it? I am working on a Mid 2009 13" Macbook pro with 2.26ghz and 8GB of RAM.
View 5 Replies View RelatedMacbook is charged up. Sounds like it's turning on but no tone. Screen stays black.
Info:
MacBook, Mac OS X (10.7.3)
There is also no display when hooked up to external monitor. No display when started in safe mode. No display when started with PRAM reset either.
Info:
MacBook Pro (15-inch 2.4/2.2 GHz), Mac OS X (10.5.8)
Mac pro has a gray screen with apple logo running pinwheel but wont load up. Tried shutting it down and restarting a couple of times with no success
Info:
MacBook Pro
My 3 month old macbook pro suddenly has problems booting up. I press power and it goes to the gray screen with the apple logo, the gears start spinning, and then it just shuts off!
Info:
MacBook Pro, Mac OS X (10.7.5)
I can hear the chime going off, but the display turns on you cannot see through naked eye, you have flash light onto to the screen to see very little, can you tell me why this is happening and how to fix this issue. Secondly, can you tell me how to fix this issue, my keyboard and trackpad doesn't work. Is it the problem of flex cable of both the keyboard and trackpad or is the related to software
Info:
MacBook Pro, OS X Mavericks (10.9.4)
My macbook pro late 2009 (10.6.7) when i press the power button it turns on, then it turns off by itself and then on again and gets a black screen and nothing more no booting sound and i just hear the fans or the Hard Drive going...
Info:
MacBook Pro, Mac OS X (10.6.7)
my computer turns on but there is only a black screen. i hear the sounds and am able to press buttons but nothing is seen. how to I fix this?
Info:
MacBook Air, OS X Mountain Lion (10.8)
having problems with my MacBook Pro. Turns on, straight into user log in. Once password is entered it tries to start up then eventually after grey progress bar has finished brings up a grey screen, then shuts down again.
I've tried starting in safe mode and resetting PRAM etc with no success.
Info:
MacBook Pro, Mac OS X (10.7.2)
my MBP is really screwing up these days. Basically the best way I can describe it is that randomly once in awhile (no matter what I'm doing, usually surfing the net) the screen flickers a few times, then most of it turns black (except usually for a small part on top that stays on whatever it was displaying before). The section between the part that stayed the same and the bottom is sort of "multicolored".
The computer does not respond to anything except holding the power button down for 5 seconds until it shuts off. If I try to adjust brightness or sound level, nothing happens. Anyway, I took it in to apple and they claimed it was the motherboard, so they replaced it. But today I had the problem again! What else could it even be? Any chance its the RAM/screen/hard drive?
Every time I moved my MacBook Lid my screen turns off and starts to flicker? Is there anyway you think i will get covered I haven't got any warranty left in it either.
View 3 Replies View Related[URL ]and i connected it just the right way. my tv says no signal. what is wrong? it doesn't get it. Macbook pro says nothing bt screen turns blue for an instant when i disconnect it. i click detect displays and nothing happens.
adittional info;
mbp is 15" 2010 i5 2.4 ghz
tv is samsung led tv bought in september 2009.
I am on a 17" macbook pro using lion and my laptop wont go to sleep. I shut the lid and the screen turns off but I hear it still going and the light in the front doesn't begin to blink like it is suppose to. I have reset the pram and the smc and its still not working
View 7 Replies View RelatedI bought a brand new Dell U2713H monitor (resolution is 2560px wide) so I had to get a dual link adaptor. I plug it into my Macbook pro 17-inch, Late 2011 and it works beautifully for about 10 minutes and suddenly the screen turns to static and i get a dvi symbol on top left. i then turn off and on the monitor and i get another 10 minutes. I was sure it was a faulty dual link cable - but i am trying the monitor on a macbook air and it is working perfectly.
perhaps the AMD Radeon HD 6770M 1024 MB card is not good enough? but i was told by apple support before i bought the monitor it is fine as long as i use the dual link cable.
My Mac pro will turn on. When the progress bar is finished filling in the mac turns off.
Info:
MacBook Pro
Anyone else noticing their new macbook air freezing randomly and the screen just turns completely black? The back light is still on but nothing is on the screen.
None of the buttons work, can't force quit anything, i have to hold power button to turn it off then back on.
It has happened to me twice already, first time when i was installing the adobe suite, second time is when I was working on a school assignment with a simulation app (not cpu or memory intensive AT ALL).