My recent MacBook Pro is losing router connectivity based on its location every few seconds. I need to be in close proximity and direct view of the router for it to stay on. The problem is not with the router, because other machines are fine.
Info:
MacBook Pro, Mac OS X (10.7.4)
So every so often after I open my laptop up my wireless will work initially but then all the sudden will stop working. All I have to do is turn off airport and turn it back on and it works again.
View 4 Replies View RelatedMy iMac, OS X ver 10.7.3 continually loses conectivity if I go awaya for 10-15 min. Each time I have to reconnect.
Info:
iMac
I have a PC laptop which also uses the wireless and has never had a problem.My Mac Pro loses access to the net every few minutes or so. I usually follow a sequence of "Turn AirPort Off" / "Turn Airport On" to cycle the connection, and this works but only for a temporary solution until it drops out a few minutes later.also link to pic here..[URL] It always shows full bars even though in the activity monitor it just flatlines or flutters near 0kB/sec. Like many others, my connection drops although the wireless signal icon remains full. I've noticed that as long as my system doesn't idle (ie - if I'm downloading something, or on a webpage which is always sending or recieving data) the wireless connection seems alright. But if I am on a webpage (for instance, this Apple website which is idle and not sending or recieving data) for a few minutes or am away from the computer for 5 minutes, the connectivity dies and I cant access the net. I then follow a sequence of "Turn AirPort Off" / "Turn Airport On" to cycle the connection, and this works but only for a temporary solution until it drops out a few minutes later. Also, can I ask that NO ONE suggest that I hook my computer up via the ethernet cable as there is no access points upstairs and I'm not going to pay a tonne of money to get one installed when I paid a tonne of money for my "AirPort Extreme" so I didnt have to (which was just over 2 years ago).
Its been a constant problem for the last 12 months and the short-fix of "Turn AirPort Off" / "Turn Airport On" to cycle the connection has driven me to madness (especially when I write a lot of information into a site for example this, and after 15 minutes I click the next button or send and dont realise the net is no longer connected and I LOOSE EVERYTHING I'VE JUST TYPED. It's happened 1000's of times.
[code]....
Info:
Mac Pro, Mac OS X (10.7.3), AirPort Extreme
I have an older Netgear router in my apt and am having trouble getting consistent internet signal. I can't even do Netflix I get error Here is my setup, any ideas?
MBP 2.4-- Firefox, 10.6.4 software
AT&T Elite dsl- 4.80 dl /0.64 upload? checked on [URL]
Netgear router--older model- does this make a difference?
My wife has an iBook G3 500mhz with 320mb of ram. She is having trouble with the airport card that is installed in it. I have a 2.4ghz wireless access point in the upstairs of my house (next to my main machine) which is sending the signal to a 2.4ghz bridge in the downstairs. House is wood frame. She is having problems connecting to the wireless network. When she can actually connect, she has to be right next to a wireless router and even then it doesn't work sometimes to connect. Is the airport card going bad in this? Is it possible that the antenna has gone bad or has a kink in it or something?
View 2 Replies View RelatedImac and iphone lost internet connectivity via Linksys wireless router. Ehternet works fine. Keep getting note about "self-assigned" ip. Ideas? I have tried everything I have found and read.
Info:
iMac, Mac OS X (10.6.8)
I just recently got Verizon Fios internet. I am having a problem with making the router they supplied my default router.I am not trying to piggy back or connect additional routers. I just want to use the Fios router.Prior to Fios, I had Time Warner and i used my own router and as soon as I opened up my macbook, it would immediately find that router as my default. Now, with Fios, when i open my "Airport" icon at the top on my screen, it NEVER choses my Fios router as my default, making me change to it every time i want to use my internet after opening up my computer.
View 4 Replies View RelatedI have a MacBook Pro 4,1 (early 2008, pre-unibody model) which has an ExpressCard slot.recommend a USB 3 to ExpressCard adapter for it, ideally one that I can source in the UK? I have looked at several via internet searches though one of the key issues seems to be having a driver that works with 10.6.8. The aim is to connect a Sony XQD card reader to the MacBook Pro via USB 3/ExpressCard to take advantage of the USB 3 speed. Sony's own XQD ExpressCard adapter does not work with OS 10.6.8 (I've emailed Sony requesting 10.6.8 driver support.)
Info:
MacBook Pro, Mac OS X (10.6.8), MBP4,1 2.5 GHz Core 2 Duo 4GB
My macbook pro is connected to the internet via WiFi router, and it very often it happens that my macbook loses connectivity with it. WiFi logo shows the same signal strength, but all browsers (Safari & Chrome) can't load webpages.
This issue can be solved by turning WiFi on and off, but it happens again and again. It looks like connectivity loses when Macbook goes in sleep mode and get's back from it, but sometimes connectivity issues happen even without sleep mode switching. I found in the internet that this issue can be solved by turning off Bluetooth.
My job does not have internet service. How do I get WiFi?
View 2 Replies View RelatedDid everyone notice a significant slowdown of network speeds (wireless at least) after installing this update [URL] on a 2011 MacBook Pro (2.0 i7 15")
Info:
MacBook Pro, Mac OS X (10.7.3), 2011 15" 2.0Ghz
My job requires me to be mobile, and I move from one office to the next frequently, to attend to various meetings etc. Every time I move from one office to the next, I have to turn WiFi OFF, and then back ON again, in order for it to re-establish connectivity. This is a major frustration, as quite often I am downloading or uploading work applications, and have to re-start the download / upload again from scratch. It's impractical to not move until these are complete.
Mac OS X Lion Version 10.7.3
Info:
MacBook Pro, Mac OS X (10.7.3)
I Have Lacie Porsche Design P’9230 usb3 (2TB) Hard Drive. This device connected with 13” macbook pro (X Lion) to usb2 port. Is there any way to connect Thunderbolt port or Firewire 800 port. If yes suggest me the converter details.
Info:
MacBook Pro, Mac OS X (10.7.2)
I have a Linksys Wireless Router and a Linksys Modem, the router is 6 years old or so 802.11b, how much faster would the Internet be if I had a combined Linksys wireless router/modem versus the 802.11b that I have now?
Would I see a huge difference? I am running my Macbook off it and an olde Toshiba laptop.
A month ago, I started to get kicked off my wireless network seemingly random. I have eight devices on the network, but only my MacBook Pro was affected. I use an Airport Extreme base station - the UFO-looking one from about 2006. This wasn't regular "can't find the network", greyed-out Airport icon kicked off - the icon became an outline and no matter what I tried, only a restart would get me back on (often to be kicked off again within minutes). Again, I have six devices on the network - my wife is in the same room, feet away, and her 2003 iBook stays on the network with no troubles. A week after I started having this problem, I noticed my battery was no longer holding a charge. I just bought a new one. My question: I didn't initially think there might be a connection between the two issues - dying battery and Airport connectivity - but now that I've had the new battery working for a day, I haven't been kicked off the network. Could the bad battery have caused the Airport to totally disconnect?
View 1 Replies View RelatedUpon receiving the monitor, I immediately plugged it in to my Macbook, using the Mini-DV to VGA adaptor I already had, for use with projectors. The monitor was good, but a bit blurry and not too sharp, due to the analog signal. So I ordered a Mini-DVI to DVI adaptor. When it arrived, the improved picture quality was immediately apparent.
However, as time went on, I noticed my wireless connectivity was getting terrible. Extremely slow Safari page load times, and upon going to Terminal and pinging my router, I would often get response times of 21000 milliseconds, or worse! I did a lot of research, on router firmware, on wireless connectivity, etc., but to no prevail. Then, on a whim, while continually pinging my router, I removed the DVI adaptor from my monitor. The ping instantly dropped from tens of full seconds to just a stable 0.4 milliseconds! Using my VGA connection resulted in no worse wireless connectivity than without it, but upon plugging in DVI and stressing the connection a bit (i.e. downloading a large file), the connection went bonkers. The pings also immediately jump from 0.4 milliseconds to a range of 1-4 milliseconds, regardless of any "stressing".
I have a late 2011 MacBook Pro 13" running Lion. I installed the recommended 2.7 EFI update (which was advised by the system update utility) and after the reboot, I could not access any network resources (couldn't ping the router). The information provided showed that I was connected to the WIFI AP and had a good IP Address (provided via DHCP). I connected an ethernet cable and got a new IP address in both cases, I was unable to ping the gateway IP address.
I tried clearing the PRAM and NVRAM but no success. I booted into the restore console and the wifi access there showed my Time Machine backup (connected to my Airport Extreme). I was confused by this as when fully booted, it wouldn't show anything on the network, but in the restore mode it could.I have begun the process of restoring from the previous backup which will take a few hours.
Info:
MacBook Pro, Mac OS X (10.7.3)
Is there anyway i can connect my iphone4 to my macbook so that i can send sms etc using my macbook , as i have my iphone connected to a music dock and its a right pest having to remove it for every message i receive.
Info:
MacBook Pro (13-inch Late 2011), Mac OS X (10.7.4), iphone is also on latest version
Formatted my MacBook Pro and clean installed Snow Leopard after I lost connectivity to any external monitor I plug in to my MBP. I noticed that as soon as I restarted with the Snow Leopard DVD, I regained the connection with my external monitor.
After format all was well until I updated all to the way it was. No problems showed until I loaded the recent update of Snow Leopard.Does anyone suffer from this? Does anyone know a solution?
There's something wrong with the Wifi connectivity on my Macbook Pro. Every few minutes, I lose connection to the internet even though it says I'm still connected to my network. I have to turn Wi-Fi off and then on for it to start working again. It only works for a few minutes and sometimes hours, but then I have to turn Wi-Fi off and then on agian. It only happens on my MacBook.
View 1 Replies View RelatedI for one am really happy to see FireWire 800 still included on these machines. I have five external HDs, all with FireWire, of which two are portables (freeagent Go). I also use two video cameras, both FW. I'd hate to lose FW connectivity too soon. Transferring data (audio, video or other) via USB has always been slow and problematic for me. Sometimes pieces are dropped or end up corrupt. FW has always been smoother and problem free in this regard. Hopefully FireWire will still be around a little longer than some expected. Rumours of its untimely demise have been greatly exaggerated of late
eSATA or lack thereof does not bother me as only one of my drives supports it and little else on the market does either. USB3 would have been a nice addition but maybe its early days yet and with LightPeak around the corner we may not need it at all. HDMI would have been a no brainer. Sorry but display port is just another Apple specific port which only serves to differentiate and annoy when common high quality alternatives already exist.
What is the best router to have for my iMac 27", 3.06 gig? I currently have a Belkin N1 Wireless Router, but it has been acting up lately, dropping my connection, requiring disconnect/re-connect.
View 24 Replies View RelatedRight now I have an old router/modem. And I want to buy a new one that has QoS...i found Linksys WRT54GL. But it has no ADSL modem...So I am asking you, Is it possible to connect this linksys router to my router/modem? But in way, that the router/modem will no longer be a router, but only a modem.
View 3 Replies View Relatedi just got sent a new Modem/Router from Verizon
model number: GT704-WG
And i have a Wireless Router from Netgear is there any way i can make both the modem and router to work together using Netgears router because the one verizon sent me always loses connection and i just dont like how it operates. I had my old modem working perfectly with the Net gear router but i guess since this has a built in Router it automatically makes it use it
Recently I've been having difficulty with some aspects of internet on my macbook. Initially I've found certain sites will not initiate downloads, (download page redirects but fail to initiate, control click - save seems to solve this problem, however remains frustrating) Also more recently I've found that I cannot download the new version of itunes off of apples website (due to the same problem, they don't have a direct link) When I tried to use software update from the menu I was met with a similar problem. Internet is connected and seemingly working fine but apple update fails to run, (Software Update cannot check for updates because of a network problem) network diagnostics fail to determine any problem, after power cycling both modem (dynalink) and wireless router (linksys) and calling isp who claims connection is solid with no problems.
View 3 Replies View RelatedUpstairs I have my AT&T provided router's wireless turned off and have plugged my Airport Extreme into the ethernet in DMZ mode. Wireless works fine in the house.Downstairs my Xbox 360's ethernet cable is plugged into my AT&T provided set-top box (receiver/DVR) and internet works fine on that. I cannot stream my media (using 360 Connect) from my mac to my xbox since they are on different networks, although using the same U-verse connection.When checking the AT&T router's system summary page I can see that there is an IP assigned to the xbox.
View 15 Replies View RelatedI have a Netgear Wireless G Router and was wondering if this is sufficiant or is there something out now that is faster/better. Mainly used for my macbook and wife pc laptop and 2 IPhones.
View 4 Replies View RelatedI just built a PC that actually works. However, I was really cheap and didn't wanna buy a wireless access card, thinking I could connect to an extra router and use this router to connect to my other router that's network enabled. Is this possible, and if so, how would I go about doing it? I tried googling it, but I dunno what this is called.
View 2 Replies View RelatedI have a Netgear router that I want to set up so it gets access from my other router (SMC I think)I don't exactly know what to do now
View 15 Replies View Related