when i start my imac it shows the apple logo, then the circle starts spinning and after a couple minutes it just shuts off. BTW i have windows on it as well so when i hold option it lets me open windows but not os
View 8 Repliesmy Imac will not start - When I try to start it I just get to see the apple and the wheel that goes around and around
Info:
iMac, iOS 4.3
My 3-month old iMac was responding very slowly when I used the latest version of Safari. So I forced quit the program. From then on, whenever I turned on the iMac, it would get stuck at the Apple logo start up screen. I had to unplug the power since the machine is getting very hot after 15 mins.
View 3 Replies View RelatedThis situation began when I put my Imac on sleep. After, the screen turned on in black whit the cursor but I couldn't do anything.
Then to rebooted the machine, the apple logo and sound began fine but the screen turned off, so moving the mouse the screen turned on in black with cursor.Â
I'd tried many ways, resetting the PRAM, SMC, repairing the disk and permission, analyzing hardware, repairing fsck files.
Suddenly, when I entered in Verbose mode, mi imac brought into user choose screen and worked fine, but when I shut down and tried to start my mac in the next day, it didn´t work again.Â
Info:
iMac, OS X Mavericks (10.9.3)
My computer starts up with grey screen,apple logo, rotating cirlce, and then it shuts off. Is there anything i could do before i take it to the apple store for help?
Info:
MacBook
My older MacBook loads to the apple logo and spinning wheel then shuts down. I havnet really used this laptop properly for a few years and is the 2007 Mac Book model. not been modified.
Info:
MacBook, MacBook 13" 2007 model.
My power mac g5 has suddenly started to shut itself down in the early stages of boot up. The apple logo appears and the spinning timer logo spins befor a complete shut down.Â
I have used my o/s disc to access the disk utility. Repair disc is not an option. Verify disc is an option but this process fails due to " invalid nodes" Â
Info:
iPad 2, Mac OS X (10.5.8), G5 PPC 1.8ghz, iPhone4
This morning, I would turn it on and it'd go to the grey screen with the Apple logo for a few seconds and then go to the icon that is a circle with a line through it. After reading online, I was able to boot it up in Safe Mode. I went to Startup Disk in Preferences. I chose the MAC OS X, xxxx and then clicked the lock to prevent further changes and then clicked restart. Now when I turn on the macbook, it goes to the grey screen with the Apple logo for at least two-three minutes and then just shuts off. Won't boot into Safe Mode now. I already tried the Command-Option-P-R keys trick like five times.
Info:
MacBook Pro
I have a MacBook Pro from 2010 I believe with iOS Maverick installed. (MacKeeper is also on there, which I just found out is apparently malware)Â
So three days ago I was watching Netflix, the image froze, but the audio kept going. Figured my internet was slow, so I waited a little, nothing happened. pressed escape to leave the full screen mode, but nothing happened. None of the keys would do anything, not even the sound or brightness keys. So I did a force shut down by holding down the power button.Â
I waited a little, then decided to turn it back on. Start up sound played, white screen with grey apple logo and loading gear appeared together with a grey loading bar. I figured that this meant it had to repair something. But after about a minute or two it just went to a black screen/ shut down. I left it off for a day, tried it again, same thing. Next day I tried booting it up while holding the shift key to do the safe boot (I knew it wouldn't work since I already had the grey loading bar anyways), same thing happened.Â
Today just woke up and turned on my iMac. It started with apple logo then I saw a cancel logo which shocked me..
View 10 Replies View RelatedMy Mac was working perfectly fine until my charger broke. I ordered a new one online that took about a week to arrive. When I got the new charger the first time I used it my Mac was so slow some apps wouldn't even open. The 3rd time I had to force shutdown and now it turns on but won't pass the apple logo. My only worries are saving the things that were on my Mac, is there any way it can save it on a hard drive even tho it won't pass the apple sign?
Info:
MacBook Pro
When i start the computer and the grey screen comes up with the apple logo etc., a grey "loading" bar has started appearing in the bottom of the screen. Takes a few minutes for it to go away. In the meantime the computer gets very hot and the fans are up to 6000 rpm. Then the os starts up, and I cannot download anything, due to the fact that it thinks my harddrive is full, though i have more than 100 gb of free space.I cant even download the 10.6.2 now due to the harddrive appears to be full
View 2 Replies View Relatedmy emac wont start i stays on the apple logo with the spinning gear? can anyone tell me how to fix it?
View 3 Replies View RelatedI am stuck in my MacBook pro which shows white screen.
1- I tried hold C to Bogor from DVD to reinstall Mac os x , but it's not working .
2- I tried hold Shift and option to log to safe mode , but it's not working .
3- I tried reset ram, but its not working.
I am stuck and can't do anything.
Info:
MacBook Pro
i just get the apple logo and a turning wheel on start up.
Info:MacBookPro
My MacBook Pro won't load past the start up page when I turn it on.
Info:
MacBook Pro
My MacBook Pro won't boot past the white startup screen with the Apple logo. After doing some trouble shooting my best guess is that the issue is either an issue with the logic board or the hard drive, but I am no expert so I may not be right. Here is what I have tried so far. I have done all these steps multiple times and the results have varied, but here are my most recent results:
1) First off, there are no peripherals connected so that is already ruled out as the cause.
2) When I try starting up in safe mode (holding shift while starting), the Apple logo, spinning wheel and progress bar appear. The progress bar fills about a third of the way then stops. I have left it for quite a long time and it still stays at a third of the way.
3) When running a safe boot (holding shift+command+v at startup) it gives me a " SATA WARNING: Enable auto-activate failed" message, and then eventually times out. Here is the full message:
4) Resetting the PRAM (holding option+command+p+r at startup) does the second chime but only results in the flashing folder icon with the question mark.
5) I tried booting up the computer in single user mode (holding command+s at startup) and running fsck -fy, it again gives me a "SATA WARNING: Enable auto-activate failed", then eventually times out. Here is the full message:
6) I tried booting in recovery mode (holding option while starting). When I do this I do not get the OSX utilities screen. Instead I get a white screen, sometimes my hard drive shows up on the screen, sometimes it does not.
If i boot in recovery mode with my osx install disc inserted the disc appears. If I select the hard drive we are just back to the apple logo and spinning wheel. If I select the install disc it goes to the apple logo/spinning wheel again, sometimes it allows me to start running the install, but then when it gets to the step where you select the hard drive to run the install on, no hard drives appear.
So that's where I'm at. I do not care about losing any data because luckily I backed up this machine right before this started happening.
Fairly new MacBook Pro with OXLion. When I try to turn on the computer, the startup noise and screen appear (grey loading screenwith apple icon). A loading bar at the bottom of the screen fills about a third up, then the computer shuts down again.
View 2 Replies View RelatedI have an Early 2008 Mac Pro 3.2 GHz dual CPU (8 Cores in total) one day I started the system as usual and the system start till the Apple Gray Logo appears and then it reboots and keep doing this in (loop)
I started the Apple Hardware Diagnose and it hangs in the middle! the Apple Authorized shop/repair people told me (after the tried to fix it) it is mostly the Logic Board
Can it be the RAM or the CPUs? my mac is out of warranty and the cost to fix it is crazy! so I was thinking I can buy the parts and replace it my self.
My Macbook Pro is not starting past the grey screen and the apple logo and the rolling circle. I have tried every method and I am desperate to do anything to start my computer even erase the entire disc. I have contacted the Apple store and they told me the cost will be equivalent to $600 to just repair it and no way I will be able to afford it. I am willing to do anything and even erase my entire disc. However, for that the instructions on the Apple page state that 'Insert your Mac OS X 10.4 or 10.5 installation disc'. However, I do not have my installation disc Is there any other way I can erase the OS system and at least reboot my Macbook?
Info:
MacBook Pro
This has been a great computer - bought new in 2004. Recently started to click "off" as it was just powering up. I thought there was a bug - so did a clean and install for OS X - but still does it. The only way to start computer is to hold the Options & Alt key and P and R key at start up until I hear 6 dinging noises of start up (why six is the magic number I don't know. But it is the only combo that works!). Once it is up and running no problems.
View 7 Replies View RelatedI have had my MacBook for almost two years and the battery had just died on me. So I sent it back to Apple and got a new one. But ever since switching over to this new battery, my computer has had issues starting up. A grey screen fades into white and the Apple logo never appears. The computer will just stay like that for hours. A friend suggested turning the power off and back on, holding apple+ctrl+P+R, which worked. However, the next time I turned my computer on, the screen stayed white again, without an Apple logo. Can you tell me what the deal is? Should I bother reporting this to Apple? Is this permanent damage I'm going to have to go thru everytime I start me laptop? Any way to fix it? Thanks.
View 3 Replies View RelatedMy daughter's old I Mac won't start. It is not backed up. We want to get some things off of it if we can. When we turn it on, we get the Apple logo with spinning wheel for awhile, then a question mark briefly and then a sky blue blank screen. Is there any hope of getting this to work? This computer is out of warranty. Does it seem that if we reinstall the Operating System we might find old data? Â
Info:
iMac, Mac OS X (10.4.4)
My mac desktop was working this morning, locked up and then when I rebotted it it stays on the logo screen. Any suggestions on getting passed it?
Info:
iMac
My iMac doesn't come up after turning the power on,the logo keeps running but it doesn't start or open the screen.
View 1 Replies View RelatedI own a 17" iMac Core 2 Duo. It has been crashing more and more lately. Now when I turn it on, it sits at the apple logo. The spinner does not appear. I tried new sticks of ram, and same thing. I can boot off a windows or Linux cd with the c key, but they freeze halfway through bootup. I ran a hard disk check also.
I shut the computer off like i normally do. It was fine and well. Went to turn it on, and saw a bar. Whats it for? Its been moving, but very slowly. It never does this. Is there malware or something causing it? I had a movie on the DVD slot, it that caused it. It wasn't spinning though.
View 8 Replies View RelatedI have Time Capsule and everything is backed up on there. My data is on a separate USB HD + Drobo, but for now I need my iMac to boot but it won't. It won't even get into the Desktop. all the guides online says double click the Install Icon this and that...I would if I can get into the Desktop !
It is just stuck on the Apple Logo screen with the spinny thing, that stops spinning!
I was working in my iMac - OSX 10.5.8 and i believe i did something wrong. I started seeing 2 restart / shutdown/ force quit links on the apple menu.
View 4 Replies View RelatedHoping someone can help - my imac (approx 15-18 months old , intel) won't start.
Last night on shutting down DPP (canon Digital image software) was hanging and system asked me if I wanted to force quit it...sadly I had switched off my bluetooth mouse and , as usually once mouse turned off switching it back on it never re connects - why did I buy the bletooth mouse and keyboard ?, so I could not confirm yes force quit - is there no way of selecting with keyboard like there is in windows ?
So I switched off at power switch. Tried to re switch on - grey screen came up, apple logo, the little timer circle but after a while timer circle stopped and nothing further happened.
have tried several more times and now don't even get timer.
