MacBook Pro :: Fan Spinning And Always Stay On
Apr 12, 2012When I turn on my MacBook pro, the fan spin on And stay always on. What can I do to stop it ?
Info:
MacBook Pro, Mac OS X (10.7.2)
When I turn on my MacBook pro, the fan spin on And stay always on. What can I do to stop it ?
Info:
MacBook Pro, Mac OS X (10.7.2)
I am desperate and really need an answer to this question. I have tried everything and had no luck.
I have a MacBook Pro (13-inch, Mid 2012) running Yosemite. Whenever I close the screen, it will fall asleep like it normally does. However, the external light will only pulse once (instead of continuously), and then I can hear the hard drive begin spinning again. The external light then stays at a constant, but the screen does not light back up.
It's like the computer falls asleep, but then only the hard drive wakes up, and stays woken up. This fact causes my Macbook to eventually use up whatever battery power it has and get warm in my backpack. The only thing I can do to preserve battery power is to shut down the whole computer and boot it up every time I need it.
Also, on a side note. My computer seems to run much slower than it did on it's native Mavericks.
Info:
MacBook Pro (13-inch Mid 2012), OS X Yosemite (10.10.1)
While browsing the web I keep randomly getting messages that my computer isn't connected to the internet. Sometimes I can load a new page in another tab, but when I go back to the tab that wasn't working and refresh it still says I'm still not connected. It seems to go in and out pretty often. I don't have this problem on my pc laptop so I don't think its my DSL. It's happened randomly since I got the Air, but seems much more frequent (probably happened 15 times today).
View 4 Replies View RelatedHow do i get my screen to stay lit up longer? It goes dim after less than a minute
Info:MacBookPro
While mirroring my screen I cannot close the lid and keep it awake. It will wake if I use the keyboard but immediately goes back to sleep, this happens repeatedly. I can leave it open with no problems.
Info:
MacBook Pro (15-inch 2.4/2.2 GHz), Mac OS X (10.5.6), MacBook Pro 2.4 GHz/2 GB SDRAM/.mac & POP
When laying down in in bed, holding the MBP vertically watching a movie or whatever, the screen will not stay open for the life of me. It's like the hinges are loose. When on a flat surface, the screen stays open, even if at an angle less than 45 degrees. I read there was an issue with this in 2008. I'll be visiting the Apple Store tomorrow.
[url]...
Info:MacBook Pro (15-inch, Mid 2012), Mac OS X (10.7.4)
The time bar at the top & dock keep disappearing. How do I keep them visible?
Info:
MacBook Pro, Mac OS X (10.6), files corrupted, recover data?
Almost every time I would move my Macbook Pro (I generally use it as a desktop, so move it very rarely) my screen would come on white and not show anything for an hour or so, (except a flicker or bleed of color here and there) when the image would suddenly flicker on back to normal. Now, it just stays mostly white, with lots of lines going up and down - the bit of 'color' in the lines does seem to match where windows should be on screen, but very generally, and it doesn't update in real-time, it 'refreshes' every so often. I attached a photo so you can see what I'm talking about.
I had my logic board replaced about a year ago now because of a faulty Nvidia 8600 chip (have a Santa Rosa MBP). I'm currently using an external monitor - which last time was exactly what I did when the chip started dying out and external display worked just fine then, despite the fact that the GPU couldn't drive the internal display anymore, so that's not a clear indicator that the GPU is fine. When I first started having this problem, I brought it to the Apple Store, and they ran the test on the GPU and said it was fine... but that was months back, so I don't know?
I'm thinking (hoping) this is a display cable issue and not a GPU issue. Also, if it was the display cables at fault, how much would it cost to replace the display cables? (internal LCD -seems- to work fine, backlight, etc., I think it's the connection..) Also, as a side-note, since my internal LCD is no longer working, how can I boot into Windows XP (Boot Camp) on an external monitor? It seems not to 'plug and play' at all, unfortunately, and I obviously can't get to the display settings if I can't see anything on the LCD!
I haz a serial problem, but I'll spare you the plea for sympathy and leave that to my psych. A less serial problem is my 2.4ghz AluMacBook. It's super great funtime, number one! The problem is when I put it in my laptop bag, the lid pops back open! This means pencils or cd's could get inside of the clamshell and damage it! I don't like to have my properties damaged so I'm wondering if there's a way I could re-tension the spring or adjust something soez that it stays shut. No, I'm not complaining about a weak spring, as with the MacBook Pros, I'm complaining about maybe a spastic spring that just can't be subdued. Is there any chance the magnets that hold it shut are weak?
View 11 Replies View RelatedI have a February 2008 MBP and am having issues with keeping it asleep. I currently have it set up as a desktop connected to an external monitor, keyboard and Magic Mouse (along with a variety of other peripherals) and I've recently noticed this issue. I'm running 10.6.1, I have tried everything from resetting the PRAM, SMC and repairing disk permissions to even installing a clean copy of Snow Leopard and restoring from Time Machine backup.
For power management, I have it set to never sleep, since I manually set it to sleep and don't want it sleeping on me when in use. I also have Wake on LAN activity disabled. Yet when I set it to sleep, at approximately noon the next day it wakes up by itself. I've even turned off the Magic Mouse to make sure it wasn't being moved by vibration and waking up the Mac. I'm completely stumped!
For troubleshooting purposes, I've installed a clean copy of SL without restoring TM backup to see if it's a program that's causing this issue or if it's a problem with a peripheral. I've yet to check back on it as I'm at work, but I'm hoping it's just software related. I'm at a loss as to what to do.
My Macbook Pro will not stay in sleep mode.
When I close the lid, it will go to sleep for about 5 seconds and then just continuously wake up, then sleep, then wake up etc.
If I press sleep for the menu it just wakes up again after about 5 seconds.
The battery is completely screwed and the laptop is often plugged in, but even when I take it off charge the same thing happens.
My iwork apps won't stay loaded on my machine purchased them from IStore and tried to load them @ least 6 times each says they down loaded then try to use the app and it's says 30 day free trial or purchase app.
Info:
MacBook Pro, Mac OS X (10.6.8)
Macbook air 2013 cannot stay connected to internet. The first fixed this problem with osx 10.9.2 only to have it re-emerge with 10.9.3 What to do?
Info:
MacBook (13-inch Mid 2010)
I have been having an odd problem the past couple of days. Every time I put my MBP to sleep, it wakes up immediately after the fans shut off. I have tried shutting down all of my programs and even killing of most of my process in activity monitor to no avail.
View 4 Replies View RelatedBeen having a few huge issues with my new MBA 13".
#1 - Putting the laptop to sleep. I put the laptop to sleep and put it in the bag and at some point it wakes back up. If I don't remove it during the day by that afternoon/evening when I go to remove it the battery is at 0% and it's fully discharged. One day I took it out a couple hours in and the fan was blowing like mad like it had been running for a while, when I opened the lid I had a black screen and it was frozen. Disabled waked for network access but it was no help.
#2 - When the laptop goes in standby and I open it back up I get a beach ball forever - I've tried to let it go for upwards of 30 minutes and it never unfreezes, but I can move the mouse around. I ended up telling the laptop not to standby when it was plugged in to a power source otherwise I ended up always losing work.
Just got my refurb MacBook the other day--went through the setup process and got up and running, but unfortunately my internet won't stay connected for more than a few minutes, and when it is connected, it is super slow!
Just some background information that's hopefully helpful. My internet has never been great--if all three of my roommates were all using our laptops or if I was downloading something for a while, I would sometimes get kicked off and have to restart my router. Speaking of which, I'm using the wireless obviously through a Linksys router. While the disconnections on my old laptop happened infrequently, I literally can't stay on the internet for more than 10 minutes with my MacBook.
I really want to use my MacBook, but without the internet, it's pretty much just sitting there and I'm forced to use my 4-year-old, dying HP.
So I got my situation with the faulty hinge worked out. This is how I did it.
Video demo of the problem: [URL]
I dropped my Unibody Macbook off at the authorized repair shop (no Apple stores around Canada). They felt that the issue should be fixed but they needed apples go ahead, so they phoned Apple about it and they denied the claim. Next, the head technician at the shop didn't agree with their verdict so he sent an email to Apple with a video of the problem attached. They replied with saying that it was normal and they would offer me a sleeve for free. I wanted it fixed so I took it a step further. I called 1-800-my-apple and spoke with their tech support. She felt it should be fixed to so she let me speak with her supervisor. He also felt that it wasn't within normal spec, so he spoke with his manager (Highest level of tech support). The manager said no, all they could do for me is offer a free sleeve for it. The supervisor eventually transferred me to customer relations, where I spoke to gentlemen. I explained the problem to him and then he asked for the number of the repair shop. He spoke with the Manager of the shop and the repair was authorized.
cannot get my macbook pro to stay in clamshell mode.I use MBP connected to a spectra view monitor, display fine until I touch the keypad then switches into mirroring mode.
Info:
MacBook Pro, Mac OS X (10.7.3)
Flash player just WON'T stay install. This has been happening for a while, but today alone I've had to re-install it 10 times. After about an hour or less everything just says "Plug-in Failure". I'm not sure what's happening..
Info:
MacBook Air, Mac OS X (10.7.3)
I returned from a trip during which I used my MacBook Air (Late 2010) constantly. Upon leaving the hotel I closed the computer and put it into my carrier and did not open it until arriving at home later that day. There was moisture on the keyboard and screen at the corresponding position in an area about the size of a 50¢ piece, I cleaned that up and turned the machine on and it booted up and then created. Several times it would turn off and on a few times without any input from me. At times it will boot up like all is well but with any keystroke it crashes to a black screen. If I had to guess, I'd say the HD is toast. It was replaced under warranty once already. The moisture is a complete mystery.
Info:
MacBook Air, OS X Yosemite (10.10)
Whenever I set my imessage picture it'll stay as long as I have the program up, but once I quit imessage and pull it back up, the picture has disappeared back to the default icon (of a blank person).
Info:
MacBook Air (13-inch, Early 2014)
it keeps sliding out. tried two ethernet cables. anyone else?it clicks it but doesn't really stay in place, i can easily yank it out.
View 5 Replies View RelatedWhenever I start up my macbook it stayed on grey background with an apple logo and spinning thing. I press and hold the shift key once and it went to safe mode and did my diagnostic and found out that some file got corrupted so I thought maybe I'll just do another start up and everything will go back to normal. Then I restart it again but this time it wont past that grey back ground w/ apple logo w/ spinning thing again. I tried to do the safe mode again and it won't let me anymore. I went to apple site and i found a bunch of keyboard shortcuts, non of those help me. Any here have any idea what might happen to my MacBook. I'm in Kazahstan for work related trip and they don't use Mac here so there is no where I can buy another snowleaopard cd.
View 1 Replies View RelatedI select my desktop picture, and it puts it as it. But once I shut my computer off and turn it back on, it's back to the Lion desktop picture. But when I go into the system preferences, it says that my picture is the one that I selected before.
Info:
MacBook Pro, Mac OS X (10.7.4), 15" Retina Display Macbook Pro
How can I get Google and Yahoo search engines to stay on "Top Sites"?
View 1 Replies View RelatedI've an early 2008 macbook Pro with geforce 8600 graphic cards.Since a few days i've problems with it, during a session my screen become a little green and pink and I've sometime the kernel panic message.When i restart, i've green and black bars on the screen, the apple is not in the middle and the mac freeze.I can't start with the recovery, even on the usb recovery disk, because after the choice of the recovery, the mac begin and freeze.I've ever try to begin in single user mode with fsck -fy command, sometime it resolve the problem but now nothing at all.
Info:
Mac Pro, Mac OS X (10.7.3)
The battery don't charge and the power adapter light stays green, I didn't noticed it before the battery was empty. I have had problems with the adapter before and just reconnected the power a couple of times and it starts to charge again and the light turns orange but if I touch the adapter now the computer shuts down.
Info:
MacBook Pro, Mac OS X (10.6.8)
My laptop drops the wi-fi connection every time the cover closes for sleep mode. It just started doing that recently. What settings should I do to make it stay connected? My other Apple devices continue to work normally.
Info:
MacBook Pro (15-inch Mid 2010), OS X Mavericks (10.9.3)
If you connect say a 13inch macbook to a 19inch monitor using the closed clamshell mode, will the picture quality on the monitor be like a stretched out version of the 13inch screen? I.e. poor, or does the macbook just act like a desktop computer and allow high quality viewing.
View 1 Replies View RelatedI recently upgraded my stock HDD to a SSD and moved the HDD into the optibay. I was hoping that using the command pmset -a disksleep 1 would mean the 5400rpm drive would go to sleep after 1 minute of inactivity and I would get nice SSD silence It usually does but something is making it spin up again all the time. I am hardly running anything on my MBP.
View 5 Replies View Related