About a week ago I received my new battery due to the recall. The last few days my power book has been great when I open my power book today it will not wake up. So i figured I would plug it in. The light stays green, does not change to orange, and still continues not to wake up. Even taking the battery out and trying to turn it doesn't work. Power cord stays green then as well.
View 4 RepliesI've recently acquired a (rather old) PowerBook g3 (Lombard if you are wondering). However, I have by yet acquired a power cord for said notebook.
The laptop was free, but the power cord will apparently not be so I expensive. Basically PowerBook will be used for writing papers, other non-Internet stuff I need to do this year (senior in high school). Right now I am using my iPod touch as my primary computer. My question is, should I go ahead and just pay the money for a power cord or should I just suck it up and wait until may-isu when I get a new notebook? Obviously I'd like to avoid paying a lot but would the money for a new cord be worth it? If not I could always use google docs for papers when I'm not at the house, how advantageous would having an actual notebook be
I searched forums etc. I have a 867 12" powerbook. The problem is that it will not turn on at all. I took the battery out and pressed a few key and it worked for a little while. Now when I plug it up to recharge the light goes green to red then off. I found a so called reset button on the apple site and lifted the keyboard and it is not in site.
View 2 Replies View RelatedI went to turn on my Powerbook G4 (Aluminum 1.67GHz Low Res) today and when I plugged it in, I noticied a kind of crackling or popping noise. I unplugged the power adapter and tried again. I knew that my battery was dying before this (could only get about 30 min on a charge). But now I cannot start my Powerbook. Whenever I plug in my power adaptor, there is no green/orange light. However, when I take the battery out, I hear the Powerbook trying to start up (hard drive spin). But then there is nothing but my fans on full blast! They will not stop and there is nothing on the screen. I left it there for a good 5 min and nothing changed!
View 3 Replies View RelatedMagSafe power cord for MacBook lights up green for one second and then lights up orange for one second, then goes dark. Battery shows MacBook has no power anymore, so will not boot. I cleaned the contacts and none are pushed down. What are my next steps?
View 1 Replies View RelatedI have a 2008 Macbook and when the power is plugged in, the light is green, however my battery will not charge, and it even says at the top "battery is not charging" If I remove the power cord from the computer it will still run off the remaining % of the battery, but If I reconnect the cord it lights up green and I never see the amber charging color. I traded out my battery as well as a different cord and still the same results. My battery will charge up on a friends macbook, but not on my own. I want to take it to the apple store but I'm at school and there is no store near me.
View 1 Replies View RelatedI just bought a powerbook, and I'm trying to get it to turn on. It doesn't have a hard drive, so obviously it won't be able to get it to boot. I just want to be able to get to the flashing folder. When I press the power button, the computer does nothing, not even the fan spins. The only indication I have that it is on is the caps lock light turns on. I've tried resetting the pram, but the screen stays blank and does nothing. I don't have any ram modules in it, so it shouldn't be a ram problem.
View 11 Replies View RelatedMy girlfriends 1.07ghz g4 Ibook's power cord broke, and we are looking for a replacement she will have a new macbook in about a month but I still want to use the ibook for a few things. I've noticed that some descriptions on ebay say that this particular book is not compatible with the cords that most of the others have. Was wondering if anyone knew which one works for sure, and maybe for the cheapest
View 2 Replies View RelatedThe cord on the 45w power brick for my iBook G4 has frayed and is no longer usable. I am considering removing the jack from the iBook cord and splicing it onto a 45w yo-yo-style cord (originally used with a 1400) that I have. Are there any issues associated with this of which I should be aware? I want to resolve my problem, but do not want to break my computer in the process, of course.
View 1 Replies View RelatedMy G4 Rev E PowerBook won't wake from sleep. The battery died and the computer slept, but now when I boot it, it gets to 3.5 progress bars and freezes. I have tried rebooting but I can't seem to get out of the resume from sleep mode.
Any ideas? It doesn't show the grey Apple screen like it does from a fresh boot, just the progress bars that show up when the battery dies.
My iBook G4 crashed on me one night, and the only way I could turn it on again was to unplug the power cord from my computer, turn it over, remove the battery, put the battery back in, plug the cord back into the computer, hold down the start button, and it would restart. Although, when it restarted, the fan would go on first, and then the computer would make the normal start sound. Some times the finder would be on the screen after I restarted it displaying a quick link icon of the hard drive. So after a few weeks, it did it again, then a few days, and then it got to the point where I had to keep my computer in the same position otherwise it might shut down.
Now, if the power cord is green everything is fine, but if I move my computer and bump the cord into the wrong place it turns from green to bright red, makes an evil buzzing sound, and in three seconds the computer shuts off and I have to restart by using the method above. If or when the power cord goes bright red I do have 3 seconds to pull out the cord before it shuts down. I then sleep the computer, put the cord back into the computer, and move the cord around until it is green again.
I took my computer to a mac genius, and when he looked at the crash report he said it was frequent, but not caused by the battery and couldn't tell me what was the exact problem. I bought a brand new power cord, but I still couldn't move the computer around to much or it would shut down.
1.) Has anyone ever heard of this happening? And if so, what causes it to be so touchy?
2.) What can I do to fix it myself?
3.) If I send it in, will they be able to fix it so that it is perfect again without having to spend more than the money assessed?
I would like to try to have it fixed. At this juncture, my only option is to send it in for $280 and hope they can fix the problem that no one seems to know what is the exact problem, or even where the problem stems from. I should add here that the battery is fully charged, and the report says it can hold about 1 hour of life, although it's more like 30 minutes, and then without warning to plug in or risk shutting down (like it used to give me) it will shut down.
Recently my powerbook g4 aluminum 15" won't wake from sleep mode, and i can't turn it off with the button. When the computer does turn off the only way i can get it back on is to open it up and reset the logic board by disconnecting the back up battery for a little bit. I've tried reseting the PMU,
View 6 Replies View RelatedWhen I try to print from my Powerbook G4 to my HP 6500 wireless printer it will not work. I have found out that if I turn off/on the printer then it will print. So, it must be an issue with the computer not waking the printer from a sleep mode. Anyone have a solution to this that doesn't consist of me turning off then on the printer? I have tried to reinstall a few times with no avail.
View 2 Replies View RelatedI was attempting to replace the hard drive in my eMac, but for instructions I HAD to follow some darn take-apart guide that said pull out the connection for the power button cord from the logic board. I didn't know that it was SOLDERED in there, and now I can't complete putting my eMac back together without doing so.
Can this be fixed without having to send it to Apple? Does it HAVE to inolve soldering, or is there an alternative? Is there a way I can temporary have my eMac power on until I get the connector fixed?
This may have been posted earlier, so sorry is this is a repeat. I've had this PowerBook since the first 17" versions came out in early 2003 and it has worked wonderfully. It even came adrift on a bicycle one day (strap broke with a brand new sleeve bag) it skidded down the road and bashed into the curb... still kept working.... other than a couple of dents and a lid that never closed again quite so well, it has been a fab machine.
Anyway, a few months ago the screen started occasionally going a green/blue tinge, almost like very fine stripes down the screen. A wriggle of the screen seemed to fix it, but it has now become quite bad, and stays like that for most of the time. I figure it must be the connection to the screen from the system, as when using the laptop for presentations (connected to a projector) all is good.
So my question is, does anyone know a easy fix? I heard that the wiring is built in, and needs the screen replacing, which doesn't make sense given it's nearly 5 years old.
My girlfriend has a 12 inch Powerbook G4. She noticed that the battery life was starting to dwindle. Tonight, she tried using it. It wouldn't power up. The battery indicator showed one flickering power circle. The adaptor has the green circle on it, indicating the battery has a full charge. However, the computer won't charge up.I've read the 12 inchers don't have separate PMUs. Could that prevent the machine from starting? She was using it earlier this evening, as she e-mailed me pictures from our vacation.
View 10 Replies View RelatedBasically I'm having issues with my newly acquired Powerbook G4. When i bought it the battery was not working at all so have now installed a new replacememnnt battery which works fine but having some slight issues. So...
First time I charged it, it reached 100% but green light never came on to indicate full charge. When I run the PB off the battery it gets to 20% and it shuts down without any warning it's low on battery (trying to switch it on after this is impossible, it clearly has no life) After the above I connect the power lead and start up the computer, the battery indicator starts charging from 20% onwards. Something fishy definitely going on and I have no idea what it could be, I calibrated the battery but it has always cut off at 20% since first charge/discharge.
My G4 Powerbook 17" 1.5mhz stays on most of the time. Only thing that really gets any rest is the screen once in a while. For this reason, is it better to just power it off the powersupply and take out the battery? Any harm done in having the battery there and charging for extended periods?
View 2 Replies View RelatedMy powerbook will not power up, I have already ruled out PRAM battery, am i looking at buying another logic board?
View 1 Replies View RelatedWhy is the green light next to the iSight on? I am not using any programs that use the thing and the thing is on! It wasn't on like this before.
View 14 Replies View RelatedMacbook pro not charging, the light stays green on the charger. But sometimes it does charge (light turns orange) only when I shut down the macbook and then restart it.
Info:
MacBook Pro
My macbook will not turn on and when i try to charge it the light stays green (faintly). I need it for my finals but i cant get it to turn on!
Info:
MacBook
It got REALLY hot. I had to snap my hand back after touching it, and my hand was red. I noticed it had turned off, so I went to see what was the matter. It felt hot enough to possibly catch fire.
View 4 Replies View RelatedThe plastic piece around the dc jack is broken and blocking the power adapter from being able to charge. Is this piece required or can I remove it? Does anybody know where I could get a replacement piece?
View 8 Replies View RelatedI recently tried to upgrade my powerbook with a new HD (see but forgot to format the drive before trying to install the operating system. I gave it another go last night but with the new disk installed and everything back in place, it would not power back up. I took it to bits again and checked everthing was connected including the little ribbon cable from the keyboard but still nothing. I put the old disk back in with the same results. there is no response from the power key at all. Everything is pushed home where it should be so I'm a lttle worried about what could have happened.
View 1 Replies View RelatedI have a PowerBook G4 with a broken power connector, and a brand new hard drive for my Mac Pro which I bought to transfer the files to. What is the best way to do it?- I could attempt to open the case and remove the harddrive myself, get a 2.5-to-3.5-inch harddrive adapter for about $10, and put it in my Mac Pro. From what I've read this would work, although I've never tried anything like it and I'm not sure how hard it would be.
View 9 Replies View RelatedI have a PowerBook G4 1.67 that shut itself down sometime during the day yesterday, and will not power back up. It's completely unresponsive to the power button, with no signs of life whatsoever.
I've tried resetting the PMU. There has been no new hardware or software installed. This has been tried with 2 batteries, and 2 AC power supplies.
There is inconsistency with the color of the AC power supply tip, as it doesn't seem to indicate the strength of the battery. Regardless of which battery or how much charge is left, the tip is Green, and will flicker Yellow very quickly once, when plugged in. It was Green following the initial shutdown, Yellow when I placed a dead battery in it, and then eventually turned Green. Now, it seems permanently in the Green / flicker Yellow state.
It did fully charge one battery while like this.
I recently purchased a Mac Mini at the Apple store. I'm using an Apple bluetooth keyboard and trackpad. Problem is, when the mini goes to sleep, it won't wake back up. Nothing I can do apart from a hard restart by pressing the start button will wake the computer up. I don't know what to do to fix this. Is it something in settings?
Info:
Mac mini, Mac OS X (10.7.4)
Is it possible to mod a PowerBook to use the MagSafe adapter instead of the regular adapter? I'd be willing to do it myself, but I haven't found any real consensus on whether or not it's even possible.
View 2 Replies View RelatedWas on my PB last night, went to pick the power cable up by the transformer and it emitted a spark, a little bang and then some smoke.
It was very very hot. It was late, and I was slow to react and it remained plugged into the computer after this had happened still charging it as if nothing had happened.
The computer is fine too.
Basically, I'd like to know if anyone has had a similar issue happen to them, and if I should get a new power cord? Or if you think it is okay to carry on using this one.
I haven't plugged it in since last night to see if it works or not, I am worried it will break the lap top.
