PowerPC :: Possible To Use Nokia N95 Telephone As Usb Modem On Powerbook?
Apr 20, 2007I am wondering whether it is possible to use a Nokia N95 telephone as a usb modem on a powerbook.
View 16 RepliesI am wondering whether it is possible to use a Nokia N95 telephone as a usb modem on a powerbook.
View 16 RepliesI have been using my phone as a bluetooth modem on my PB for quite some time now, but today I get an error saying it is unavailable. But it is a different message than when my bluetooth on phone is off. I have a HTC Touch Pro, Alltel (CDMA). The reason I use bluetooth is because I don't know how to use USB tethering (which would be nice as bt makes my phone quite hot). Anyways, If anyone can help with either problem, it will be GREATLY appreciated. I am currently posting this on my phone, as I have a 10hr car ride and no comp.
View 1 Replies View RelatedI am leaving for a week long trip and many parts of it will not be able to run the computer off of the powercord, which is a problem because I get about 40mins of wordprocessing use out of it when I run the battery alone. Can someone explain what the significance of these levels are for my Powerbook G4 15'' (Alm) 1.25GHz, namely the cycle count and full charge/remaining capacity?
View 8 Replies View RelatedI have an old PowerMac G3, (Yosemite) and I thought about adding a 56k fax modem to it just for kicks. Question is: will a PCI fax modem work in the powermac g3? It's running Mac OS X and the modem is rather new.
View 1 Replies View RelatedThe iMac is a G3 Slot-load SE, and the PowerMac is a G4 450MHz AGP. I happen to have an AGP that only came with the telephone jack, but no modem card connected inside. Both modems look the same in photos: 661-2213 (slot load) & 661-2186 (AGP). Is the only difference that the newer one has flex K56?
View 2 Replies View RelatedI have a Power Mac G4 MDD that I am trying to connect to the Internet using a USB Cable Modem from Broadstripe Cable in Maryland.
So far I have tried a straight connection using the supplied USB cable, then via an Ethernet adapter from the USB cable to the MDD. Went through the software setup several times and still have had no success. does anyone have a solution for this type of problem?
an older retired couple, recently got cable modem access specifically so I could have it. They are the coolest, nicest people on earth. I'd like to get them on my wireless network as a
View 1 Replies View RelatedMy 12 inch powerbook does not start up. Instead it loads to Darwin. I have an install disk from a 15 inch powerbook G4 and I would like to know if using this would work on my 12 inch powerbook G4?
View 3 Replies View RelatedWhat can I buy to strengthen my signal without modem? I have a lot of problems connecting to the internet while in some of my classes.
View 3 Replies View RelatedIs there any sort of "bridge" software that allows a terminal emulation program, say, Z-Term, to use Skype as a modem? It seems silly to pay for connections to BBS's when I've got SkypeOut, but I haven't been able to find a way to do this.
View 6 Replies View RelatedI have a Powerbook G4 1.5 w/ 1GB of RAM and the stock 80GB HD. I've run this puppy pretty hard for a couple of years now, and it's lately started to lag a bit - perfectly natural. I was considering buying a new notebook but I've decided to wait until after Leopard comes. So my question is:
1) How do I determine the max RAM I can put in this machine?
2) Are there are specific specs I need to be concerned with when swapping out the Hard Drive? Any type, size limitations, speed limitations, etc.
I'd love a little input as to how I find out this info. I think instead of taking the notebook plunge now, I'm going to put a nice new hard drive in this one and possibly bump up the RAM a little more if it will take it.
So is the is Powerbook G4 802.11g or b? it is the 1.25GHz model. Also, one thing I don't understand regarding the airport extreme or any airport for that matter: isn't the maximum speed going to be completely determined by how much the cable provider, Comcast, pumps out?
If this is the case, how do I determine what my transfers and speeds are looking like specifically for Comcast? And, how would an airport extreme improve upon this or any other performance aspect in this regard?
Powerbook G4 (Ti-book) 667 mhz, 512 mb RAM. I finally after YEARS upgraded my OS (10.4.10), yay me! Just bought Adobe CS3 (for the new IMAC we have yet to buy), but I would like to install it on my Powerbook. SO, it it time to bump up to 1GB RAM. I was told it was tricky, and I should take it in to the apple store to install, but then I took a look under the keyboard, and it looks pretty simple. i have installed new RAM on a G5 tower, and this looks way easier. So, I am planning on buying the RAM either online or at FRY's, then installing it. BUT, I know I have to be careful of what type of RAM to buy. I found what I think will be good at [URL] but I will have to buy 2 (512's) as mine currently has 2 (256). I guess I just want to make sure I am not going about this the wrong way before I drop about $200 for RAM upgrade...
View 3 Replies View RelatedI have a 15' Powerbook G4 1.67, currently with 512 of ram....so i'm shopping for an upgrade, but not sure which specific type to go with. In my system profile it says i'm running..
Type: DDR SDRAM
Speed: PC2700U-25330
And these are the types i've been seeing to choose from.
G4 15-inch 1.67GHz (DDR M9676LL/A) Memory
G4 15-inch 1.67GHz (DDR M9677LL/A) Memory
G4 15-inch 1.67GHz Double Layer DDR2 (M9969LL/A) Memory
I just bought a used 12" powerbook G4 1.5ghz and I want to add some ram to max it at 1.25Gb. Did anyone try to use ddr400 instead of ddr333 on powerbooks? In theory it will run at 333 like in any pc, but is this flawless in powerbooks? Because ddr333 is expensive nowadays.
View 3 Replies View RelatedI know the powerbook is rather archaic now, but I'm trying to get a new Macbook and don't want to throw my old powerbook away. So.. I have a friend who wants to buy my old G4 Powerbook with 60GB capacity, 512 MB memory, 1.33 GHz cpu speed. It's extremely worn in, meaning, it won't last more than 20 minutes off the power cord, but someone could always replace that. So what would be a fair price to charge someone to take it off my hands?
View 1 Replies View RelatedI bought a powerbook G4. The ram is 512 mb but i want to upgrade that. Is it possible to place two 1gb cards in each slot. That i have a total of 2gb ram? Me was told that the max of the powerbook G4 is 1 gb. Is that true? And when it is true, is it smart to buy a total of 1gb for the powerbook g4? Or doesn't make that any difference?
View 6 Replies View RelatedI believe the hdd is dead so I need to find a replacement but I've no idea which cause there are 93487534231 kinds. Only thing I can really find via googling is that it has to be a 2.5" ATA but there are several different kinds of ATA hdds... so confusing. I was thinking this? [URL]
View 7 Replies View RelatedJust replaced the logicboard on a 01' Powerbook G4 Titanium Onyx and I'm getting the no video/beeping sound after the chimes upon power up.
3 beeps
3 lights (1 long + 3 quick flashes)
I don't THINK it's the RAM though, I thought these cards were good before the computer fried. I've swapped the two 256MB cards with each other, also plugged just one RAM card in both slots one at a time--still no turn on and I get the 3 beeps. Unfortunately I don't have any extra 144-pin 133 Mhz SDRAM chips laying around or i'd just test them. It seems unlikely that both RAM cards would be broken, in addition to the logicboard frying, unless the two events happened simultaneously. Previous install had the 667 Mhz upgraded processor and when I took the logic board out it was fried on the bottom with lots of corrosion/leakage on a good 5% of the surface area. Anyways, I replaced it with a 550 Mhz board. Could the beeping be from installing the different processor or is it more likely that I simultaneously fried both RAM chips plus the motherboard?
Do you guys think it would be worth it to spend the $50 to upgrade from 1.5GB ram to 2 GB ram in this machine with Tiger on it?
View 7 Replies View RelatedI am kind of new to the MAC world... I once had the really old ibook with the handle a long time ago..and I never got a new Mac due to some problems I faced!
But now, I want to go back to MAC because many things were developed and I missed using a Mac! So, now I am confused between the Powerbook12 inch or the White Macbook 2Ghz ? I really love the size of the Macbook but I am worried about the intel processor...?
This is ridiculous. After I went out and got a new screwdriver to install my 1GB stick of RAM, which I got off of Newegg, it is now not recognized by my computer. So now I'm running with 256MBs of RAM. Beautiful, thank you Apple.
[URL]
This is what I ordered...Crucial Technology 1GB 200-Pin DDR SO-DIMM DDR 333 (PC 2700) Notebook Memory - OEM
I thoroughly made sure this was the right RAM, and even people with my same type of computer have said it works on their posting thing.. 1.5 GHz PowerBook G4 15". Anyone know how I can get this to work?
My PowerBook 12" 1.5G has 100% CPU usage when playing back the new TV program from iTunes store. And sometimes it even choke.
While I have no virus scanning software, some programs running such as Opera, iTunes, Entourage and have about 20% CPU usage when idle.
Why is it so slow on a PowerBook while you can actually play that video on an iPod? Is it the iPod too powerful or it is just because apple did not optimize enough for older Macs (pushing people to new hardware)?
I have just ordered a new iMac but I am not happy about my PowerBook which is just one year old.
I have an older 15" G4 Powerbook (before the recalled Powerbooks with the RAM slot failures) that has recently been experiencing some speed issues. To my dismay, when I checked my 'About This Mac...' I no longer had 1GB of RAM, only a lowly 512 MB. Tonight I sat down and started swapping and removing my two sticks of RAM and as it turns out, something is up.
With a 512 stick in the lower slot, System Profiler tells me I have 512 MB of RAM and that the upper slot is empty. When I put the other stick in the upper slot (leaving the lower one in), System Profiler now says I have 512 MB of RAM and that the lower slot is empty. Does this look to be a (out of warranty) logic board failure? Is there anything else I can try to do? On a related note, when removing the screws from the RAM panel on the bottom of my PB, one screw fell into my Powerbook, never to be seen again. Is this going to cause any problems down the line?
I think my backlight went out?
I restarted and nothing. Still dim. I can barely, barely see things like if I hit expose, I can see shifting rectangles.
Also, I've been having this issue where the keyboard mostly stopped working -- if I hit kjjh, it'll come up as 3443 or something. It's usually fixed with a restart.
I have it covered by a year of applecare until feb 24, 2007 -- but I haven't registered it yet. Should I register and then call apple or what?
This comes at a REALLY bad time. I have design projects coming up everywhere and of course, despite my $250 external hard drive, i haven't been backing things up because I'm an idiot.
Can I hook it up to a external monitor just to make a backup of my hard drive?
Is it possible to get 2 gigs of RAM into a Powerbook (12") or is it stuck at 1.25 gigs?
View 2 Replies View RelatedMy Friend has a 15" Powerbook (2nd last rev.... 1.67ghz with lo-res screen) and it's been on the fritz lately. It operates completely normal and then it suddenly goes to sleep. When I wake it up it's back to normal just fine. It goes to sleep after about 3 minutes of use.
View 1 Replies View RelatedI recently replaced my 12" PowerBook G4's 60 gig HDD (due to failure) with a 80 gig HDD (TOSHIBA MK8026GAX).
I'm now running out of space and am looking to upgrade to a 100-120 gig HDD (and put my existing TOSHIBA MK8026GAX HDD in an external FireWire caddy).
After research, my two options are: 1 - TOSHIBA MK1234GAX, 2 - TOSHIBA MK1032GAX. Both offer good performance in my price range.
Option 1 is a 120 gig HDD with a 8MB buffer. Option 2 is a 100 gig HDD with a 16 MB buffer.
Obviously I would like as much space as possible with the best performance. Would I see a large drop in performance going from a 16 MB buffer to an 8MB??
All the drives have similar specs (seek times, etc), besides the buffer being smaller on the 120 gig HDD.
Do I spend my money on a 120 gig HDD with a 8MB buffer, or a 100 gig HDD with a 16MB buffer??
Check this thread out for more info [URL]
My G4 Powerbook 17" 1.5mhz stays on most of the time. Only thing that really gets any rest is the screen once in a while. For this reason, is it better to just power it off the powersupply and take out the battery? Any harm done in having the battery there and charging for extended periods?
View 2 Replies View Related