I finally pulled my old, very dead, Powermac Dual G4 MDD out of the closet. I like the case design so much that I would like to keep it around if possible. Only thing is I'm not sure what I can do with it. Plant pot, aquarium, lamp, etc. Any ideas of what this thing can become in it's afterlife?
View 9 RepliesDoes anyone know if the PB 15.4 Aluminum case is exchangeable with the Macbook Pro 15.4 case? I have a 1.6Ghz Powerbook which has a few dents in the front but I don't see any of these cases for sale on Ebay, but I do see Macbook Pro cases. It's really a nasty cosmetic issue I'd like to resolve and then sell it.
View 1 Replies View RelatedI am looking for a tear down guide for my 4 core power mac. I need some instructions on how to remove the CPU's since I bought this for $100 and found the part for $250.
View 2 Replies View RelatedI like eMacs but the G5 looks sooo nice. I know I probably won't be able to use any for very long but whatever. What is the best?
View 24 Replies View RelatedI have a Powerbook G4, 15-inch, and I need a case for it. What I really want is one like this from Incase
[URL]
Except that I need it to have handles. I could swear that at one time I saw a case by Incase at an Apple store that was just what I wanted but I was stupid and did not buy it and now cannot find it anywhere.
Basically I want as minimal of a case as possible - it need not store anything but the computer itself (such as power cords, etc.). Does anyone have any suggestions?
So recently I found a cheap powermac G5 on ebay and won the deal and all, but when the computer arrived it was horribly dented. It was packed with on piece of under a 1/2" Styrofoam. In the end I got a full refund for the computer and the seller just said that I could keep it if I want it. So I wanted the thing on my desk so I went ahead and bought another case for it. Now here's the question, has anyone done this or knows how to do this? I want to keep all of the internals inside for it not to become a month or so long project in my spare time. I am not sure on a tool that would let me get up into the edges. If you want to see some video of the unboxing of the case and at the end some footage of the dented one and how bad it is go here.
View 7 Replies View RelatedI have an iMac G5 (Ambient Light Sensor) that runs Leopard pretty slowly, even with 2GB of RAM. Sometimes, it's a pretty severe lag: Type a sentence, twiddle your thumbs, bam, it's all inputted at once. Sometimes, the whole system is non-responsive for 60-120 seconds, before, bam, accepting all your key- and mouse-strokes at once.
Activity Monitor also reports extremely high CPU-usage. I've been using it for a couple of hours this morning and it's been maxed-out or nearly maxed-out basically the whole time.
There aren't any processes that appear to be hogging resources. Sometimes, it's finder / time machine that's using the most. Sometimes it's Safari or Mail.
I'm open to the possibility that it's just time to upgrade, but I was wondering if the forums had any suggestions on how to troubleshoot or reclaim some CPU cycles.
i know that this may sound very crazy. I am wondering if it is possible to take everything out of a powermac g4 computer and put it into a standard atx case. i am trying to make a huge data server and need a lot of drive bays. i found 2 that i am considering: coolermaster with 11 bays or lian li huge case one other thing- is it possible to use a regular power supply or is that propriatary? I think with all of the drives i am going to put in it, i am going to need a more power.
View 16 Replies View RelatedWhat do you think (or use yourself) is the best thing to use to clean the Aluminium case of a PowerBook? I've got smudges in a few spots and I'm not entirely sure what to use.
I think I've heard people mention the Mr. Clean Magic Eraser (the dry kind), does that work? Or does it just destroy the Aluminium?
Putting a new DC In board into my iBook this afternoon, but I'm stuck on opening the bottom case. I've got all screws apart from the Hex screw in the middle of the case, which will not come out at all. Im using a T8 Screwdriver for it, the same one that got all the other hex screws out.
View 4 Replies View RelatedIt came with a carrying case, but I want a little more protection, like a snap on case? My cousin has a MacBook Pro and has one. And I want one exactly like it! But I haven't been able to find a similar one for my PowerBook If you don't know what I'm talking about, look here: [URL:...]Something along those lines. I've been looking for one for awhile but I can't seem to find one.
View 1 Replies View RelatedI have an old-ass desktop PC that I wanted to upgrade (especially a gaming machine), so I was looking through a good case. However, I really LOVE the Mac Pro/ PowerMac G5 cases. The silver one with lots and lots of holes in front And then I saw some PowerMac G5's on sale at my local authorized mac reseller, for a very nice price. it got me thinking, I can buy that PM G5, take out the innings, put it to my old desk-top case to use at home (since it's dual 1.8ghz or something like that, which should be very powerful) and use that CASING of PowerMac to build my new computer. So here's my REAL question:
1. would that be a good idea?
2. Would all the components, ATX Motherboard, a nice graphic card that's big, (thinking of GTX 260 or ATI 4870) fit inside? And also, what's the built-in power supply at?
I have a Dual 1.8 GHz PowerPC G5 with 2.5 GB of RAM. My fan starts revving really loud when I am using multiple apps (Adobe CS2, Firefox, iTunes) and while watching a video tutorial or AVI movie (both saved on my desktop). It also happens when I am just watching a AVI movie with no other apps open.
I just added one GB of RAM yesterday thinking maybe this will solve the problem since I am running multiple apps. This did not resolve it. So I searched the messageboard for threads on fan issues similar to mine. I read it may be caused by the tempature in my room. I keep the tower on my floor on top of 2 pieces of wood about a 1/2 inch thick. I live in a small brick studio apartment so the tempature is usaully between 60 to 70 degrees.
I looked into smcfancontrol but it looks like its for laptops only.I also do not have a utilities program for my computer yet. I was wondering what was the best program out there to clean up/tune-up my hard drive so its running at maxium speed.Has anyone had experince with this issue and have any answers? I am concerned this may be very detrimental to my computer in the long run.
I'm curious if anyone has a fairly surefire method to remove scuffs and scratches from an iMac G5. I picked one up from a friend for $50 that needed new caps in the power supply (check) and was pretty roughed up cosmetically. Now I've decided to keep it as a kitchen/guest computer but would like to get rid of the scratching as much as possible.
View 5 Replies View RelatedI went through all the steps to change the optical drive on an old 500 MHz iBook G3, but am unable to attach the bottom case. The problem is the two long (20mm) screws near the back of the computer -- each apparently has to insert into something that looks like a gold-colored nut with serrated edges, like gears, otherwise the screws just rotate in place and don't "lock up." I'll attach a picture, but my only digital camera until I borrow one from a friend is my cell phone, so the pic won't be too good. The gold pieces fell out during the disassembly process and I can't figure out where they now go.
View 4 Replies View RelatedI'm attempting to get at my screen, but I'm stuck. I have removed the 2 hex screws at the bottom of the screen casing. Now I how do I pry off the case?
View 1 Replies View RelatedYesterday I did something stupid and accidentally flattened my powerbook while it was open. This caused the casing around the left hand side of the monitor case to separate.
The part that frames the screen itself. Do you think the whole monitor is shot or will it just be an easy and relatively simple issue to fix. The screen works fine in fact I am using it right now, I just am afraid of dirt and don't like that it looks this way.
If I want to take the hard drive from my defunct G4 Mac Mini and put it in an external enclosure, will this work?
View 2 Replies View RelatedWe have an old eMac but it works pretty well for our daughter's needs. We have a mysterious problem where the lower case 'r' won't work. I thought the keyboard was faulty and bought a new one but have the same problem with that so it's in the system somewhere. The uppercase R works.
View 5 Replies View RelatedHi, I just acquired a PowerMac G4 500mhz that works great. However, the hinge is broken. It is on the right side (if you are sitting at the laptop). The screen casing is broken where the hinge is. There is nothing wrong with the screen, just the aluminum cases that covers it on the edges. I was able to remove the broken hinge from the computer. My problem is attaching a new hinge to the case without damaging anything.
View 2 Replies View Relatedhow to Repair a Powerbook G4 17" case?
View 1 Replies View Relatedi've been searching for a way to use an iMac G4's LCD Monitor as an external monitor for any other computer. So far i haven't found a solution for it, so during my search i read that it is possible to remove the LCD display from the iMac G4's case and install another LCD display that you know for sure it will work on any other computer. So, my question is, is this possible? if so, what LCD monitor would fit in the case? i know that there's a problem when trying to pass the wires through the arm, but i think i can handle that since i already tried with some random cables, so if you know of an LCD that could fit in the case.
View 3 Replies View RelatedI recently bought a Power Mac G5 with 3 20" cinema displays, each with their own video card. I've since stopped using one and it sped up some. But even with the most simple tasks, it is hella slow and freezes sometimes. If I just have Firefox and iTunes open, it runs slow and the fans kick in overdrive. The main video card is an ATI Radeon x800 with 256 RAM and the other is a 9200 with 128 RAM. how to free up my RAM and speed it up?
View 5 Replies View RelatedSo a friends girlfriend tossed, as in threw, her older ibook g4. You ask why? Well she was mad at it so she punched the screen and it cracked, so she gave it a quick toss because the screen cracked. So I get to be the one to try to salvage the harddrive. I have the ibook torn apart, my macbook, a macmini and an external usb IDE harddrive enclosure at my disposal.
So I tried to target it through my macbook by holding down T and booting up the ibook. Hard drive clicks and spins, but nothing mounts on my macbook. So I bought an external USB for the ibook harddrive. My macbook won't see it when connected. So does this mean a bad drive? Do the older drives have to be connected by firewire?
After reading about Psystar and all that crap I have become inspired. I want to build my own hackintosh . I have an old G4 Gigabit Ethernet PowerMac that I aquired a few weeks back. I was wondering if it would be possible to gut it and use the case for my new hackintosh. Will a standard mobo fit in it? Can I easily replace the powersupply?
View 24 Replies View RelatedI curently have 10.3.9 with a PowerPC G4 dual w/ 1.25 processors and 2 gig of ram. I want the highest upgrade I can get that will be compatibe with my software which is:
Quark 6.5
Acrobat 7.1
Acrobat Distiller 7.0
Illustrator CS1
Photoshop CS1
Microsoft Office (don't know what version but I've had it for years)
I really can't afford to go buy all the software again and I don't want my system to crash. Any suggestions?
This upgrade is mostly spawned due to the recent purchase of a new iPod Nano... Not supported by my current OS! Man, I didn't read the requirements, shame on me. However, the dang thing will work on my kid's PC w/ XP Pro. I only got the Nano cause it's mac - he wanted the Zune that ONLY works w/ PC.
I was wanting to know how hard it is to change top and bottom case and keyboard area? I would like to know that if anything was to happen to my soon to have macbook I could change it. Also this on the older macbooks. And if I have Apple to change it how much would it cost? And yes I know that they should replace keyboard case area for free because of the defunct cracking issue.
View 3 Replies View RelatedThe Graphite 733mhz PM G4 has only 3 ram slots. But the "fourth" one shows up on my system as "empty". Does this mean that it may be physically possible to put another ram slot in there? I'm confused by the limitation -- though I heard that Mac OS9 could only recognize up to 1.5gbs of ram.
View 2 Replies View RelatedI have about 50 *.mp3's on my hard drive that have the file names in all upper case. When looking at them in itunes it drives me nuts....Is there a way to convert the uppercase file name to lowercase? I have googled but can't find anything. I do not want to do it manually, that would take a long time =( thanks, I'm crossing my fingers
View 11 Replies View RelatedWhere i can replace the aluminum case, is it possible?, i search for spares and didn't find any.
View 2 Replies View Related