Intel Mac :: Unable To Complete Snow Leopard Installation After Performing HDD Erase
Mar 29, 2012
I experienced what I believe was a crash so after various attempts at doing a time machine restore, I performed an erase of the HDD and have been trying to install snow leopard from a disk I bought from the Apple store. I am not sure if the disk is the whole OS X or not as it was purchased to upgrade from the OS X that was on the machine. I am hoping to do a time machine backup to get my old programmes/software back afterwards but in the meantime just cannot seem to get snow leopard on my iMac.
Question: I already have snow leopard installed on my iMac. But can I still do a CLEAN snow leopard installation onto my imac even though snow leopard is already installed?
I tried it just now like twice but I got the spinning wheel of death. It wouldn't go pass the apple sign and spinning wheel.
Recently installed Snow Leopard. Mail not working. Tried to update Mail but Destination Selection portion said, "Mail Update can't be installed on this disk. This volume does not meet the requirements for this update."
Here's the deal: I have the most recent 17" UMBP, purchased last August, 2009 and got the Snow Leopard Up To Date Disk, did an install on my stock Hard Drive and have been VERY happy with everything for the past few months.
But... All these threads championing the latest Intel SSD G2 have finally gotten to me and, I just purchased the 80GB model from Newegg. It should be here tomorrow.
Now, I ask that you confirm, a specific question about installation from my UTD disk and then advise.
note that I've searched a ton about this subject. It's been answered in so many conflicting ways, I'm running it by you guys once again.
So then, it seems that I can NOT install Snow Leopard from my UTD disk onto the new, fresh Intel SSD installed into my 17" UMBP. This is the case, yes?
A workaround, I figure, would be to install Leopard 10.5 onto the new SSD and then to a clean and erase and then instal of 10.6 on top. I assume the UTD will read 10.5 and let the upgrade proceed.
So, finally, a question: Should I be worried about installing a total of two OSs given that I (cheaply!) opted for the smaller 80GB SSD and that 10.6 doesn't support TRIM?
In a few weeks time I'm getting my Mac Mini upgraded to 2GB memory for Snow Leopard when it comes out. My Mac Mini is a 2006 Intel Core Solo model, and in September I'll be wanting to buy Snow Leopard but I want to be 100% sure that my Mac Mini will be able to install Snow Leopard since its DVD media. I know I can't burn DVDs with this Mac Mini but, although may seem like a stupid question will I be able to install Snow Leopard with it being DVD media.
I just tried to upgrade my iMac to snow leopard (10.6.3) from cd.It remains stuck on the start page since hours : white page with grey apple logo and no spinning wheel or progression bar.
My iMac running OS 10.4.11 can't complete startup. It opens a couple of windows, then reverts to a blue screen, over and over, no matter what restart procedure I try, including the OS X installation disk.
Info: MacBook Air (11-inch Late 2010), Mac OS X (10.6.8)
I recently attached a WD 320G external drive and am trying to use it to back up with time machine. However everytime i start to back up, time machine quits before finishing. I used time machine buddy and this is the message that i got:
Starting standard backup
Backing up to: /Volumes/G4 Time Machine/Backups.backupdb
No pre-backup thinning needed: 56.78 GB requested (including padding), 159.78 GB available
Waiting for index to be ready (101)
2012-05-15 13:36:06.986 ReportCrash[3227:2907] Saved crash report for backupd[3233] version ??? (???) to /Library/Logs/DiagnosticReports/backupd_2012-05-15-133606_localhost.crash
For now I have used Carbon Copy Cloner just to have a back up, but would like to have Time Machine for automated back ups.
Info: iMac 2.4 GHz Intel Core 2 Duo, Mac OS X (10.5.6), MacBook 1.83 GHz Intel Core Duo 1GB 667 MHz DDR2 SDRAM
I have moved a network time machine backup disk to a new computer. Now when the time machine starts a backup it produces an error message: "Time machine could not complete the backup. An error occured while creating the backup folder."
I have a macbook running leopard and am upgrading to snow leopard. I have a back up from leopard on an external hard drive and I would like to completely wipe my computer, start fresh. However, I no longer have the leopard install disc but I do have the old tiger install disc. I am thinking to revert to tiger to restore the computer's settings and then upgrade to snow leopard. Will I still be able to restore select items from my Leopard back up?
About a week ago I enabled FV1. Overnight, the encryption and deletion of the original folder appeared to complete.However, I now have a never ending 'Secure Erase' process showing up in Activity monitor. By never-ending, I mean its always there, although as far as I can tell the secure erase process finished days ago (and surely, on 54GB home folder, it shouldn't take this long anyway). In any case, Finder shows my disk space as freed already.I'm not experiencing any lag in the system, no increased fan speed or temp; in fact, the only way I know its happening is because it
i. appears in AM and Top
ii. it strips the life out of my battery when I'm not on AC Power.
I've tried re-booting to no effect. I've even tried killing the process but it just restarts itself.In Finder from within Snow Leopard, I see two home folder images. There is one with a home icon that appears to be an alias. 'Get Info' says it has 0MB size. There is another 'no access' folder whose size is indeterminate, as Finder never completes the 'Calculating' process.However, looking at these same two folders from Lion (on another partition), the folder with the home icon shows up as a 54GB sparse bundle. The folder with no access remains inaccessible and of indeterminate size.The issue is not critical. If the worst comes to the worst I can wipe this disk and re-install from a clone, but I'd rather find a better solution, if possible.
Can't install the applications dvd, it says an error occured and i have to contact the software manufacturer for this. What will i do to have it installed (i life)?
I'm trying to erase my hard drive to sell my MacBook and well I used the drop in disk to help with this. I dont have the gray disks that came with my computer. Any who I ran it erase and reinstall the os and at the last second it failed to install. Now when I start my computer with the disk it'll try to down load the os and it says that I don't have an OS X version 10.4 or higher on my computer. So basically I don't have a operating system on my MacBook. It's empty. It is a white 13 inch MacBook.
iMAC with OSX10.9.4 ; 8GB ram ; two partitions external disk formatted MAC jurnaled ; connected via Fire Wire or USB2 .
During Backup the sistem get stack and display into the "details window" Time machine was unable to complete the backup because unable to complete the backup folder.
This problem happens with USB and Fire Wire. The file backups.backupdb is excluded from virus scanning.
Also happens time to time that (without doing things) both the partitions of the external disk disappaire from the desk-top and a message "the disk must be ejected properly" is displayed.
This two problems are independent une to the other. I have change the backup disk but both the problems persist.
Info: iMac, OS X Mavericks (10.9.4), 8GB ram ; external backup HD
When installing Snow Leopard, will it erase my hard drive and force me to start all over or will it just update the software and keep everything the way it is on my Mac now?
When I go to update ITunes on my MacBook, it says it downloads and says the installation is complete. However nothing has happened, the software is still the same. This is also the reason I cannot sync my IPhone as my software is not up to date.
I cannot complete the Adobe Reader Free installation to print or read documents, I get to the final install and the program does not install. it is in my downloads but I cannot finish the final steps?
I turned my 2011 iMac on this morning but it never loaded past the startup screen. Eventually the Apple icon which is usually displayed on the screen turned into the broken folder symbol. I read some articles on how to fix this and tried resetting the NVRAM and PRAM, but that didn't work. I was going to try reinstalling OS X next, but putting the disc into the driver doesn't appear to do anything, and now I can't eject it.
So I've only had my macbook pro aluminum body for about 4 months and after downloading the new system update, my laptopl just started acting weird and then it would just keep freezing with the pinwheel for extended periods of time. I've decided to verify and repair the disc, but to no avail, it didn't help. So, I backed up files in an external hard drive and erased my disc. However, after repeating to reinstall Snow Leopard at least 10 times, it keeps on telling me that it has failed to copy supported files. If I eject my installation DVD, it will just show up with a gray screen that has a folder and a question mark on it. I'm not sure what to do. I feel like I should take it over to an Apple store to consult with a Genius...but it is far from where I live. Any easy step to step advice on what I should do?
I've installed Snow Leopard but now my mac won't start up. (It's a early 2008 mac pro so it should be able to handle it). All that happens is it loads past the apple logo, the rainbow wheel pops up, the background loads and the search icon (magnifying glass) appears but nothing else at all beyond that. It just waits for ages (a few times that note has appeared that say's I need to restart the computer).
I've tried. 1) Re installing it 2) Reinstalling it on a different partition (that had windows on before) but nothing seems to work. I really need to keep all my data so I want to be careful.
So I had an aluminum 2008 unibody macbook. I replaced the hard drive with a 320gb and it has leopard on it. I damaged it and had to get a new mac. I now have a white unibody mac. To copy every thing would be a pain. I'd rather use snow leopard. What I want to know is if I can use the reinstallation disc 10.6 that came with the white macbook to upgrade my 320gb leopard hdd to snow leopard?
I bought a used MaxBook (2,0 GHz Intel Core Duo , 2 GB RAM, 80GB HDD) and try to install 10.6 Snow Leopard (Family License).The MacBook HD doesn't have any data on it, as the pre-owner completely cleaned the HDD. I put the SnowLeopard CD in the CD-Drive and press the C-Button during booting and start the install process according to the dialog that shows up.The installation starts and shows me in the beginning it will take 34 minutes to install. The process continues till the countdown shows 28 minutes’ and then the installation process freezes. I only here some repeating noise from the CD-Drive but nothing happens. I tried this process now several times, I was waiting for hours that the install may continue, but no success so far.... Does somebody have any idea what I could do install 10.6 successfully? I don't think it's a license issue, but I want to add that I also own a MacMini and with the same install CD was successfully installing 10.6 on the MacMini.
I assume an upgrade to SL will not remove any applications i currently run, unless I do a so called "clean install", but I just wanted to be sure: What will get removed when I upgrade?
My applications that are not 64-bit compliant? Will they still work? Will my adobe software still work, or does it need an update? Does any of my applications need an update? I have some custom icons (through Candybary), will they be removed? Will all my personal preferences reset?
Basically, what will an upgrade to Snow Leopard touch and change on my system?
How do I get iLife 08 (which came preinstalled) onto my Mac after I do a fresh installation of Snow Leopard (if possible)? Is it possible to do a fresh install of Snow Leopard? I've heard all sorts of things, but I don't know what to believe. Will I just have to reinstall Leopard and then install Snow Leopard? (Will I have to get all the updates [10.5.x updates] once Leopard is installed before I install Snow Leopard?)
I'm upgrading my mac to snow leopard but I don't really have a external hard drive to back up my data or the software to do the backup. Is it safe to do an upgrade without backing up?
