I have a 20" G5 iMac with iSight that will not power up. No chime or screen activity. The first diagnostic LED is on which I assume means the power supply is OK, but the other LED's are off. Can any recommend what trouble shooting steps to take next?
Info:
iMac, Mac OS X (10.5.8)
i have a imac with i sight emc 2124 just went pop turned off and wont power up again ive removed case and look at logic board and all caps look ok no leaking or funny shapes.
Info:
iMac
I've got a 20" 2.1GHz iMac G5 iSight on my bench that doesn't power up.
I've tracked down the issue to a grenaded IC on the logic board.
The IC is an 8 pin SOIC chip, to the right of the power connector, just above the ALS connector. It is labeled UE300.
If you know what this guy is, can send me a good picture of one, or can provide me with the numbers from the IC, I can get this mac back to life.
My mother's iMac G5 began this just two days ago. It turns on fine, but once is reaches the apple logo with the spinning wheel, the screen begins to exhibit what is shown in the pictures below. It first started when I opened an .AVI I received in an email from my uncle. When the file opened, the whole screen(within about 2 seconds) had discoloration and macro blocking spread from the center of the screen outward. After this I rebooted, tried again, and when I opened the file, it did the same thing. Now I can not even reach the log in screen. And after the screen has been in this state for a while, it may go blank and the fans run at full blast. I've opened the same file on a PowerMac G5 and a MacBook Pro with no problems.
View 7 Replies View RelatedAt work, we have a 17" G5 iMac from back before the iSight was put in. We're an Apple shop, so we have the new iMac actually on the floor for people to try out. The old G5 this thread is addressing is up on a shelf, but we want to turn it on as a display model. We plug a temporary mouse and keyboard into it, but the machine never gets past the white Apple screen with the "I'm thinking" animation. After a minute or two, the fan turns on full blast, but the white screen remains without any signs of moving on. What is our problem?
View 6 Replies View RelatedIs it possiple to use isight as a webcam, in order to post updated images or video on a website?
If so, how so?
Information:
G5 2.5 GHZ
Mac OS X (10.4.7)
My iMac stays on 100% of the time, but a few months ago I turned it off for about 18 hours during a storm. When I turned it back on, I got the flashing question mark. I turned it off & back on about 8-10 times, when it finally booted up just fine.
It never does it at a reboot, only if off a while. For several months, it did this any time it was off a while.
About 6 weeks ago, it stopped doing it! Now, I can't MAKE it happen!
I should feel lucky, but I'm also nervous about an impending failure. When SL came out, I repartitioned the drive, first going to MBR, then back to GUID, just to re-write everything. That neither helped (the issue was already gone), nor hurt.
during the day I want to be able to record what's happening on my screen including both video and audio. I want to follow a realtime webcast when I'm away from my computer but this webcast isn't played thru the browser.
View 1 Replies View RelatedI played a video at [URL]using Safari. When I opened the activity screen I could see the advertisement part of the file loading. When the main video began to play I could not find it and therefore could not download it.
Info:
iMac, Mac OS X (10.7.1), iLife '09
Suddenly yesterday when I powered mi iMac I had some horizontal green bars on the startup screen then it powered normally. But it happened two times, now every time I power on my iMac the screen stay black, and i can use my computer, everything else is working normally (i still can use Alfred to turn off my computer).
I already tried resetting the Command+Option+P+R, it didn't work. Also the Safe mode.
I have a mid-2011 27' iMac. EMC 2429.
when occurs a suspension of hard drive activity, manually or after a period of inactivity, this suspension seems to be incomplete (a ventilator continue to run) therefore my mac (power-mac G5, OS 10.4.11) is unable to restart, no possible action from the keyboard (I must shut down and restart)
Info:
PowerMac G5, Mac OS X (10.4.4), & PowerBook (10.3.9)
Recently my iMac had been experiencing problems, I took apart and checked everything and put back together. Problems were gone but the screen suddenly started gradienting from brighter on the top to darker on the bottom. Brightness overall is also lower now.
My question is what can be creating this? The black tape that was around was ripped, I've heard it's creating static isolation, can that be it? Also I possibly pulled power cord too hard, can it be possible that display is not getting enough power?
I have a 2009 2.53ghz 8gb 500gb 7200 macbook pro, running latest version of snow lep 10.6.4. It's been running fine since I got it last august, now today I started it and I get the blue screen that seems to refresh itself with a slight flicker every 10 seconds with a new blue screen with the spiraling activity dots. I tried booting from a disc, and it nothing changed. I tried booting in safe mode and it the bar would fill up, then it goes right back to bluescreen. I don't have a screwdriver on me, so I can't take the battery out.
View 13 Replies View RelatedI am getting HD noise like every 20 seconds. Even with no activity. Per the suggestions of another user, I typed this in terminal: iostat -w 1 disk0
And the sound seems to coincide with the output whenever the first column has a value other than 0. So it seems there is activity, it's just not user initiated. Is this some kind of energy saving feature that apple is doing or is it a logging application? Is anyone else having the same issues? Even if you're not, could you run the program and check for 1 or 2 minutes (without any other apps open or doing anything) to see if you also get a value other than 0 in the first column every so often and an associated sound?
[Code]
I have a new, week 7, 27" iMac with 2.8 quad core CPU. Activity Monitor shows the "% idle" number jumping anywhere from 49% to 99% (but usually stays around 49%), when I'm actually 99% idle. The "% user" and "% system" numbers are less than 1% when the computer is idle. They just don't add up to 100%. Does anyone else see this? The left top of the computer is hotter than any computer I have had before. This is the third computer that Apple has sent with this problem. Apple Care just says to send it back.
View 5 Replies View RelatedDoes anyone know of a completely free application that will allow me to take screen recordings and have a video of me talking in the corner simultaneously? I know there are high-end versions of this, but I just want something that will get the job done.
View 2 Replies View RelatedI noticed that something was running in the background when I . I checked activity monitor to see what was running and saw that a process named "Find" user name "Nobody" was running. It disappeared before I could inspect it. Does anybody know what process this is and what application may be running it? I'm now paranoid!
View 2 Replies View RelatedWhen i open photobooth, all i get is the camera logo with a line going thru it... When i open ichat, it says no camera is attached... There is no green light, in system profiler under USB TREE, the isight is not even recognized....
View 2 Replies View RelatedI keep getting the message "No cameras connected" when i go to Photobooth.It worked just fine a couple weeks ago. I havent done anything except surf online since I had it on last.
View 2 Replies View RelatedHave a 17" G5 iMac iSight (OS 10.5.8) that works normally for several hours and then the CPU temperature suddenly spikes and the computer shuts itself down. When I check the Temperature Monitor (application) history graph, it shows normal temperatures and then a spike. There are 3 fans and I don't know which is failing or whether there's something in the temperature sensing that's gone haywire. My only solution is to do a forced restart. By this time, things have cooled and it will work for several hours.
View 1 Replies View RelatedAs of yesterday, I'm having problems with Facebook and Chatroulette not recognizing the built-in iSight on my iMac. The camera is recognized on Skype, Quicktime, Photobooth, iChat, etc.
Has anyone had the same problems and what did you do to fix it?
Have been searching all over for My 20" iSight G5 iMac won't start.
Already tried:Removing power cord Using other power cord Inserting power cord while holding down power button Holding power button for 6 secs+ Plugging cord to wall outlet Begging and praying to the mighty white apple.
I purchased the last generation iMac G5 when it came out a few years ago and I recently tried to sell it. I sent the item to the buyer and he said it would not start. The Apple logo or for that matter anything would not come up. He brought it to the Geek Squad at Best Buy and they said it was an issue that would most likely cost over $500 in repairs. I just got the computer back in the mail and all that happens when the power button is pressed is the white light on the front lower right hand corner comes on for a second, then the machine shuts down. You can also hear the machine begin to start for about two seconds, then it shuts down. Any ideas as to the problem and whether it is fixable without expensive repair costs?
View 6 Replies View RelatedI read a few posts about dead pixels on the iSight, so I thought I'd post this picture to see what other people think. This is a screenshot straight from Photobooth, showing the image from my iSight when the black cleaning cloth is held up to it. No, those marks are not dirt (on the outside anyway). Other that this, my iMac is fine with the exception of a single dead pixel (I thought this was a thing of the past, but oh well) and I'm not 100% about whether or not I have the yellow screen issue, so I'll ignore it for now.
View 3 Replies View RelatedBesides putting a piece of paper over the iSight, is there a way to manually disconnect it so that no one can remotely login from the outside and view it? I am assuming that even a firewall would not be enough. This news story made me think about it: [URL]
View 1 Replies View RelatedI have looked everywhere, including under the right speaker. Have removed the display ... they are nowhere to be found. But I know they're hidden here somewhere!
Info:
iMac, imac g5 isight
I have a 15'' 2010 macbook pro that I've only owned for about a month and a half. At first the isight camera worked great,I used it multiple times for photobooth. But a few weeks ago I tried to used it for skype and noticed it just showed a black screen. I thought maybe the problem was just with skype, but I started checking other programs and it's the same in all of them. The green light is on and it's recognized in system profiler, but the screen is black.
A few days after this happened, the problem seemed to fix itself, but then it went right back to the black screen 2 days later, and had been that way ever since.
I tried resetting the PRAM, but it didn't help. Is there anything else I can do, or is it time to give in and take my macbook to the Apple store?
I've been using my macbook for a few months right now, and primarily use it for recording me and my band-mates on Logic express, but now, I've not been able to use my iSight on my mac. I don't know what's wrong with it, because I've always been able to take photos with friends in Photo Booth and take movies with it as well. Up till now that is. A few days ago I tried to open up Photo Booth and snap a picture, but all I got was a blank screen. The program would count down, but the screen would just be white instead of showing what it would take. The little green light next to it would go on as well, but it wouldn't take a picture, and nothing is blocking the screen either.
View 2 Replies View RelatedI will be traveling overseas soon, I have a PowerBook and an Intel iMac, I want to be able to access some files from my PowerBook while I'm away, and at the same time, can I use the iSight in my iMac as a surveillance camera? Unacceptable answer: "use the search function, has been covered several times!". Acceptable answer: "go to bed, you obviously need some rest".
View 6 Replies View RelatedAccording to the Guides section of the forum, the built in iSight cams use a USB bus connection to the system. Has anyone ever "harvested" the iSight from broken iMacs or MacBooks and wired them for external use? I would imagine that they'd make great fixed focus surveillance cams.
View 2 Replies View Related